Yamaha 350 4x4, runs fine in neutral and reverse but when put in drive just sutters and barely goes at all before dying out. It will start right back up. Any ideas?

SOURCE: my name is james, i have a 1982 yamaha xt550 that

The first place to look is the Kick stand safety switch,This will cause the problems you are having,If it is going bad or not contacting completely.(You can bypass to test it,if need be )

Check that and then post back if you still have any problems.

SOURCE: yamaha warrior won't start

a yamaha warrior isnt a 2 stroke. they make a street bike nad a four stroke quad. Check your carburator. check your spark plug and check your stator. it may be very minor considering it was running fine then just went out. no noise or anything. you would have heard something if you broke something internal.

SOURCE: I have a 2003 Yamaha TW 200 and it starts and runs

see if there is a saftey switch on the kick stand that is probally your problem also chek the clutch cable adjustment put in gear pull the clutch and try to push it if its hard or locks up you need to adjust your clutch cable

Greg O'Day

• 376 Answers
• Posted on Jan 02, 2010

SOURCE: I have a 2006 yamaha apex mt,I got reverse put in and not workin

You got to take the chain case cover off and check the chain. Chould be broke or stretched.

SOURCE: I have a 2003 yamaha kodiak ATV, reverese indicator light stays

MAKE SURE THAT FORWARD AND REVERSE ARE FULLY ENGAGEING AND DISENGAGING