2007
SOURCE: What do I need to do to change spark plugs on a
Some basic rules I've learned and all of 20 minutes out of you life. People complain about valve noises or sluggish throttle response, well a crisp set of plugs firing does a lot to resolve these issues and for only $10 (standard plugs) is the cheapest performance mod going.
1) Replace your plugs annually (or at a minumum follow schedule of rear tire replacement) regardless of amount miles.
2) Plain and simple. Don't waste money on iridium because of #1 they spark the same it's just the tips that are suppposed to last longer.
3) Full removal of the tank is not needed but you will need to move it out of the way. Remove seat, remove center speedo and disconnect connectors, remove tank bolts, disconnect vent tube at the front portion of tank, lay a towel across the frame where seat normally goes, lift tank and turn tank sideways it will rest there without removing gas lines underneath, stock air box removal is not needed (BAK is even better for access), not certain what they mean by rider's seat bracket (at the back of the seat?) but obviously this is not needed either. There are wires zip tied to the frame that might need to be pushed out of the way or carefully cut the zip ties and just add new ones when done. (This just allows better access to get to the spark plug on right rear cylinder.)
4) A long screwdriver with small hose on end helps retrieve and reinstall plug on the front cylinder (unless you have very long fingers)
5) Go to auto parts store and purchase a socket with universal swivel for proper angle to losen or tighten plugs
6) A small amount of anti-seize compound on the threads is never a bad thing unless you use too much or it smears across the tips which would probably burn off anyway but that's just sloppy mechanics. (You want to be a sloppy hack like that, well you're outta the club... Go ride another brand.)
7) Use your hand never the socket to start the threads on the new plug. Place new plug in hole near cylinder and spin in reverse to align the threads then go in normal direction. If it does not feel correct at the start - never force it.
8) Do not over torque the spark plugs when tightening.
9) When reconnecting coil wires make certain you press down enough for a positive click to ensure proper connection.
10) Put tank and seat back in place and prepare for the response "why did I wait so long..." on the first ride...
Hope that helps.
SOURCE: i need to remove the exhaust for a 2007 yamaha stratoliner.
i think you will find that the cables you are referring to as powervalve cables (if you are talking about the xv1900 in the picture)are not powervalve cales you will find that they are for the auto decompression valve in the cylinder head,if you follow them back you will find they terminate on a lever with a tensioner you can back off the tensioner to remove them but shouldnt have to just to remove the header,hope this helps
SOURCE: I have a yamaha road star xv1600a/at motorcycle it
How many mile are on the bike? There is no hydraulic lifers in your bike and if you are hearing a ticking sound then I would have to say it would need a valve ajustment.
SOURCE: tire pressure for stratoliner
For riding 2 up I recommend 38 front and 42 rear. Some riders have commented on some front wobble corrected by putting the front to 40 psi.
SOURCE: I have a 2007 Yamaha
Hold the select button for at least 2 seconds on the left side of your handlebars. The switch is on the backside of the controls.
1,304 views
Usually answered in minutes!
×