Yes heat it up and bang it level.
SOURCE: i want to give me bike a sevice
You need at a minimum, a shop manual for your model. Check at http://www.suzukiownersclub.org/usa/ for a manual. Look in the tools section for guidance on what special tools you will need for this.
SOURCE: Gear shifter adjustment
The VZ 800 ,has a linkage system ,it can be adjsted to suit your needs .Firstly , your linkage attaches to the front foot lever.on the other end the linkage attaches to the actual gear box.Its this part that you need to adjust ,Undo the bolt that holds the linkage bracket to the gearbox spline. slide the bracket of the spline .undo all the adjusting screws on the linkage rod ,position the gearbox linkage unit to the required angle you need to position the foot lever to the popsition you want and the adjust the linkage rod to suit the distance between the garebox liinkage unit and foot change.
SOURCE: Carb Problem GZ 125cc
A plugged up main jet in the carb could be the problem. Remove the float bowl and clean the carb. I prefer removing the entire carb from the bike then doing the cleaning. Carb cleaner can mess up the paint job.
Clean or replace the air filter. Another possibility is the muffler could be partially plugged up due to mud or a collapse of the pipe inside the muffler. Disconnect the exhaust then see if the problem is gone. Also, be sure you have clean oil in the gearbox, a well oiled chain, good gas, and a new spark plug.
52 views
Usually answered in minutes!
×