97 Suzuki intruder 800 backfires when leaving a stop sign.
SOURCE: backfiring and low compression in back cylinder
sounds if you have a burnt valve/s somewhere
SOURCE: 1997 suzuki intruder 800 starter is running
The guys are right. Has to be a polarity problem. Check the connections.
SOURCE: 1997 suzuki intruder 800
Sound like it's time to get the carbs looked at.
It wouuld seem your float is bad, stuck, or not properly adjusted,; thus causing too much fuel to enter the cylnder
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
SOURCE: My suzuki intruder is missing backfiring on the
Did you sync the two carbs? If not the rear may be getting all the gas from the rear carb and none to the front. Twist throttle engine off and see if front carb cable is pulling the carb open.
Also unscrew the spark plug boot from the front spark plug wire and trim 1/8th inch off the wire and screw the boot back in. The plug wire end may be corroded on that wire.
SOURCE: 1997 Suzuki intruder. Runs fine,
If the spark is there then the ignition is working well : the CDI is generating the spark correctly, at the right moment - you can't have a timing issue at only one cylinder. That cylinder overheats and starts to detonate the mixture because there are carbon and calamine deposits in the chamber - you will need to remove the head and clean it and the piston.
772 views
Usually answered in minutes!
×