Question about Yamaha RD 350 Motorcycles

1 Answer

92 yamaha warrior is stuck in 3rd gear with rear end locked up has play in gear shift lever

Iv fixed atvs before but iv nvr ran into this problem before i just bought the wheeler nad i have no clue what to do i need help

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Yamaha Master
  • 1,190 Answers

You need to strip gearbox , selector or shaft or gear damage !

Posted on Jan 15, 2014

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
fastboyz

paul erickson

  • 674 Answers

SOURCE: QUAD QUESTION! 1998 yamaha warrior 350 bogging down

sounds like fuel starvation
do you have a petcock plugging or a dirty carb?
pull the fuel line and check flow
later paul9477792.gif0e30a9b.gif

Posted on Nov 17, 2008

johnnyraptor

  • 89 Answers

SOURCE: How do I adjust the valves on my 2003 Yamaha Warrior YFM 350X?

first you need to remove everything that covers your valve covers(gas tank etc.) remove the intake valve cover,and the rotor nut and timing plug.set the engine a t.d.c.(top dead center)fit a socket onto the rotor nut and turn it counterclockwise until the"I" mark appears align it with the index mark in the timing hole.use a flat feeler gauge between the top of the valve and the adjuster.loosen the locknut and turn the adjuster just until you feel resistance on the feeler guage.hold the adjuster and tighten the lock nut down.i can not tell you the min.clearance spec to your quad since i have a 660 raptor.try using the smallest clearance number.

Posted on Apr 25, 2009

tbrat44

  • 86 Answers

SOURCE: The trans is stuck in 3rd gear. wont shift

sounds like the shift lever shaft broke internally. if you know enough to take it apart and repair yourself, you will firure out how the gearing works. also check shifting forks for defects, make certain thier not bent or this problem will happen again.

Posted on May 07, 2009

Anonymous

  • 1 Answer

SOURCE: QUAD QUESTION! 1998 yamaha warrior 350 bogging down

I had a problem somewhat the same.

Make sure the air-intake boot has no holes in it.

Posted on Jun 14, 2009

Adrian762

Adrian Ahrens

  • 425 Answers

SOURCE: When I shift my 02 GSXR 600 the gear shift lever gets stuck

Get yourself a repair manual and find out what it says, but I think you are correct, the return spring is either broken or it has slipped. Try this site for a freebie manual:
http://www.carlsalter.com/motorcycle-manuals.asp

Posted on Jan 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yamaha warrior is stuck in 3rd gear nad rear end is locked up and there is play in the shift lever but wont click into any gear


sounds like gear box needs stripping and check allcogs and selecter forks etc for wear or damage! happened to me on a yamaha rd 200 ! P...

Jan 02, 2014 | Yamaha RD 350 Motorcycles

1 Answer

Where can I find the exact timing sequence for a suzuki four wheeler


every four wheeler I've ever worked on has the ignition timing fixed and controlled by the CDI. Mechanical timing usually invovles lining up the T on the flywheel with a mark on the cam shaft. you'll need a service manual for more specifics.

Aug 03, 2013 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

I have a pull start 3 wheeler, and the pull cord will not get pulled back in. How do I fix this? Ride daily, and can't fix it.


could be the spring is worn,loose, or you have taken it out before you didn't tighten up the spring.

Aug 25, 2010 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

New ATV. Ran 1 hour. Sitting for 6 months. Changed gas - but is popping back through carb


sounds like the gas that was left in the carb. has turned bad and clogged the jets. the only right way to fix it is to pull the carb off the bike and take the bottom bowl off. once done you can take some carb. cleaner and spray out all the jets and crevices inside the carb. hopefully this fixes your problem. if not then you will need to pull the carb. completely apart and give it a good soaking. once you have soaked it for an hour or so take some compressed air and blow out any holes. be sure to blow it out good. once done put the carb. back together and give it a shot. this should fix it right up for ya.

Jun 20, 2010 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

1987 polaris trailboss piston


Sure - it is worth fixing when a new one is 2300

Mar 31, 2010 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

Ran fine yesterday, but now kick start spin freely


Broken return spring is my guess or it has come off the holding post.

Feb 23, 2010 | RTO Quads 125cc Full Size Adult 4 Wheelers...

3 Answers

We have a New ATV 250cc that will not start..getting fuel,getting spark, engine just turns over!


  1. eHow
  2. Car Repair & Maintenance
  3. Car Oil Maintenance
  4. Drain Car Oil
  5. How to Repair a Polaris Four Wheeler
How to Repair a Polaris Four Wheeler By Brianna Byrne, eHow Contributor repair-polaris-four-wheeler-800x800.jpg Spark plug inspection and adjustment can be one way to repair a Polaris ATV.

Almost every vehicle needs regular servicing and repairs in order to continually perform at its best, and Polaris' lineup of four wheelers is no exception. The company has released dozens of ATV makes and models throughout the years, ranging from sporty racing quads to youth models to heavy-duty utility ATVs. Despite the differences between the company's many makes and models, general repair tips and troubleshooting instructions remain consistent for all Polaris four-wheelers. The electrical, ignition and fuel systems are some of the most common sources of Polaris ATV problems.

Read more: How to Repair a Polaris Four Wheeler ' eHow.com http://www.ehow.com/how_8074861_repair-polaris-four-wheeler.html#ixzz26pmQIzeh

Nov 21, 2009 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

How to take a four wheeler engine apart


got a 150cc marchin atv but it ran 3 or 4 times then it quit working it makes a nois like its about to crank but it aint workin and body out there who can give me any solutions

Sep 15, 2009 | RTO 200cc Full Size Four Wheeler ATV

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1176 Answers

Paul Ellermets

Level 1 Expert

6 Answers

Neil Lancaster
Neil Lancaster

Level 1 Expert

14 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...