Where is the brake light switch on the 82 hd flt

Is it the talilliight or the brake light? If it's the brake light, check the front brake switch inside the right handlebar control. The plunger may not be working properly.

U have more than one tv?Yes.Tries check on the other tvs see if u have channel 82 freeview channel,freeview channels are take out or add on all the times by the tvs stantions broadcasting listing.If yes channel 82 is on the other tvs.Than u have low or weak antena signal.U have a analoge antena probally correct?Buy and install a digital antena,u will get a stronger longer ranges tvs incomming broadcasting chaanels tvs stations.Rescan for channels again,u will pick up channel 82 if it still on the air.

check the wiring to the rear brake lights fo r voltage. If none you have an open wire between the bulbs and the brake light switch you already replaced

There are two brake light switches. One is in the right handlebar switch housing. This is front brake light switch and is a simple push button type switch actuated by the front brake lever.

The other switch is a pressure switch and it is located in a Tee usually somewhere under the bike near the rear of the transmission. Follow the metal tube coming out of the rear of the master cylinder. It will go back towards the rear brake. Somewhere in that line there will be a tee with the pressure switch in it. If you jumper across this switch, the brake light should work. If it does work when you do this but not work when you depress the rear brake signal, replace the rear brake light switch.

Good luck
Steve

The conditions that set this code are as follows:

The PCM monitors changes in input voltage on Brake Switch No. 1. If the PCM does not sense voltage changes at PCM terminal 82 when alternately accelerated and decelerated 8 times, the PCM determines that brake switch No. 1 has a malfunction

Possible Causes are:

• Brake Switch malfunction
• connector or terminal malfunction
• Short to power circuit between Brake Switch terminal D and PCM terminal 82
• Open circuit between Brake Switch terminal D and PCM terminal 82
• Malfunctioning PCM

http://www.carlsalter.com/motorcycle-manuals.asp

try starting with the bulb. brake light bulbs are dual fillament, meaning you have 2 bulbs in one basicly. if your brake side has blown then the tail light could still work. Or try checking the brake light switches, one on front brake and one on rear brake pedal. to test switches disconect wires and join them together with small bit of wire or paper clip. this will make the light come on meaning you have a bum switch.
if you have only been using the rear brake, that has an adjustable switch, may need to mess with it