Yamaha 82 virago 750 Float bowl is spotless floats set at carb body split no holes in diaphram new needles everything clean. Bike starts very easy. wams up fast ( close enricher after 15 -30 seconds) If you blip the throttle it stalls .if you try to slowly roll the trottle it stalls. If I open the float bowl drain screw a quarter turn on each carb I can blip the trottle "a little bit" but it wont rev at all. Someone said to check the tci.....If I dont have a known good one, how can I check it? could that be the problem?
Hi m8y,, soundz to me the float heights are wrong,,have u tried that at all, u can only check that when the carbs are taken out and turned upside down,, all four floats should be the same height,, check wot the measurements should be in the manual,,if u have one,, if u havent try these guyz 4 a downloadable manual,,, www.repairmanual.com ,, if all is cool and correct,come back in m8 and il take u threw the next step,, cheers
415 views
Usually answered in minutes!
i cleaned the two carbs. the float is all good. put it back together and still does the same thing
×