Temp too high - Multistrada 1000 DS Ducati Motorcycles

Most A/C units do not have a high temp cut off - heaters of the other hand will likely have a high temp cut off. What is the brand and model of the device you're asking about??

Did you check behind the toe-kick panel for the tech data sheet? Assuming that you have checked and that it is missing, there here is the "secret keystrokes" that will make most Whirlpool/ KitchenAid/Kenmore/Maytag diswashers enter the diagnostic cycle:
Heated Dry - Normal - Heated Dry - Normal; or
High Temp - Air Dry - High Temp - Air Dry; or
Hi Temp Scrub, Energy Saver Dry, Hi Temp Scrub, Energy Saver Dry; or
High Temp Wash, Heated Dry, High Temp Wash, Heated Dry.

Note: On some of the newer Whirlpool, Kenmore, KitchenAid dishwashers, you start the diagnostic cycle by rapidly pressing the 3 left-most keys in the following sequence: 1 2 3, 1 2 3, 1 2 3.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Press "high temp wash, heated dry, High temp wash, heated dry, high temp wash, heated dry, high temp wash, heated dry, high temp wash"

All the lights will go solid at which point you press cancel to reset the board.

**NOTE** if you don't have a "heated dry" button, use the "air dry" or "energy saver dry" button instead.

Press "high temp wash, heated dry, High temp wash, heated dry, high temp wash, heated dry, high temp wash, heated dry, high temp wash"

All the lights will go solid at which point you press cancel to reset the board.

**NOTE** if you don't have a "heated dry" button, use the "air dry" or "energy saver dry" button instead.

The most common "reset" key sequences are:
Heated Dry - Normal - Heated Dry - Normal; or
High Temp - Air Dry - High Temp - Air Dry; or
Hi Temp Scrub, Energy Saver Dry, Hi Temp Scrub, Energy Saver Dry; or
High Temp Wash, Heated Dry, High Temp Wash, Heated Dry).
On some of the newer Whirlpool, Kenmore, KitchenAid dishwashers, you start the diagnostic cycle by rapidly pressing the 3 left-most keys in the following sequence: 1 2 3, 1 2 3, 1 2 3.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

check condensor fan if it has one. if not unit may have sprung a leak some where

P4 code outdoor compressor air exhaust temp too high/outdoor ambient temp too high/ compressor enclosure temp switch break off/module temp too high. Compressor is not running because it has an over temp alarm. Fix/repair thermocoupler

The high limit thermostat should have been replaced also.
If there are no obstructions that will fix your problem.

than either replace heater sensor or element.
Give me model number pls

I misplaced my diagnostics paperwork, but I found you here and you saved my life!  The wife is much appretiative! 

 

~Teddy Bear