SOURCE: how to put a yamaha dtr 125 engine back together
Hi hope this helps
1. place enging clutch side down on wooden blocks either side
2.place in gearbox and drum and selectors making sure all gears select by turning drum. (Tricky bit)
3. locate crank and tap into place, not damaging threds. also locate balencer.
3. place on other crankcase gentle tap together so there is no gap and tighten together with bolts.
4. next fit clutch, flywheel and piston and head.
SOURCE: need wiring diagram for electric start yamaha dtr
Here's a link to the whole manual... good luck!!
http://www.ebooksquad.com/2009/02/21/2006-yamaha-dt-125rdt125x-owner-manual.html
SOURCE: hi there i have a yamaha dtr 125 thats smokes
Assuming you are using two stroke engine oil, the pump is pumping too much into the gas. DO NOT use motor oil in the gas. If 2 stroke oil is being used, then get a new pump, fix the one you have or disconnect the pump and mix the oil with gas when you fill up. Four ounces of 2 stroke oil per gallon of gas equals the standard 32/1 fuel mix.
SOURCE: Loss of compression with dtr 125, kick start
change the rings anyway then you know if its them,cheap and easy to replace
SOURCE: my dtr 125 wont start
too much fuel buddy on carb is a mixture screw turn this in 14 of a turn or more if required and try this if no good get back to me
56 views
Usually answered in minutes!
×