80 cu stator replacement - 2000 Harley Davidson FLSTC Heritage Softail Classic

the Heavy Duty 80 Series Extra Capacity Plus is 3.5 cu ft.

Its more than likely because the stator in the 80 is designed different so that the point of ignition is advanced to compared to the ignition on the 04. Try to retard the ignition as far as you can if that don't work you can either buy the right stator or file the holes for the screws wider so you can turn it more.

try here, if you know a stator is the problem, you can measured it, disconnect stator connector on the rectifier, it should be some resistance between 3 wires, and no resistance from wires to ground, or start the bike and measure the voltage between 3 wires, it should be ca 80 V/AC

https://www.youtube.com/watch?v=6UeGOumRXU0

The LE code is displayed when the motor goes into an overload situation, if you have changed the Hall sensor and rotor, the only other problem is the stator overheating which will bring on the LE display.
Check the stator assembly, replace is faulty.

Samsung has us replace Mems sensor, main harness and user interface board. They do not have away to test the mems sensor in the field.

check fuse on positive to battery,if not blown the check feed wire from stator plate to regulator should be around 80 to 120 volts ac.
if low voltage then you will need a new stator/alternator.www.thepitstopcardiff.co.uk 999pounds 50cc lifan on the road 3yr warranty

Hi, yes you have either a faulty stator or regulator/rectifier. Check if you have ac voltage out of the stator to the regulator if so the reg is bad, if not the stator is bad. Regards Phil.

Hi,


LE code stands for locked motor error. When this error code appears in your front load washer it indicates a fault in the motor unit.

1 . Check the connections to the Coil/Stator at the rear of the unit possibly it should be something like a broken wire.


2 . Coil/Stator Assembly will be defective preventing the drive to operate.You should go for a replacement of that assembly.


Thank you !!

I cannot find a MQU8057AEW in the Maytag library. I did find a MQU2056AEW that is 20 cu ft.

It is an overcurrent error and only two thing that your washer is in trouble with.The winding in the stator assembly is short circuited or the main board is bad. Check the winding.

1. Remove the back cover.
2. Remove the large bolt in the center shaft. You may need a helper to hold the inside of the drum.
3. Pull the rotor off the shaft.
4. Remove the two screws from the tub bracket.
5. Remove the six bolts on the stator.
6. Unplug the two connectors on the stator.
7. Pull the stator off the tub.
8. Grab a multitester and measure the resistance between the terminals of the 3-pin connector on the stator.
9. Resistance should be between 5 to 10 ohms, else replace the stator with part number 1266809. Price ranges from $100 to $150.
10. Install the new stator in reverse order of disassembly.
    
11. If resistance is between 5 to 10 ohms, replace the main board. Part number 1268306 and costs about $65-$80$
    

• Remove the 2 screws on the back of the top panel.
• Pull the top plate backward and upward.
• Disconnect the POWER connector and SENSOR
  SWITCH ASSEMBLY from the main board assembly.
• Remove the Protect Cover.
• Disconnect the connectors.
• Remove 1 screw on the back.
• Disassemble the Main PWB.
• Install new main board in reverse order.