2004 Yamaha YZ 450 F Logo

Related Topics:

A
Anonymous Posted on Aug 08, 2013

I have a 2004 yfz 450 that wont idle, not sure why anymore

5 Related Answers

Anonymous

  • 293 Answers
  • Posted on Nov 27, 2008

SOURCE: changing engile oil 2007 yfz 450

the service manual is on this link .
http://www.scribd.com/doc/2634179/yzf-r1-manual

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 10, 2009

SOURCE: Yamaha YFZ 450 engine serial number

im unsure but arent they on the sterering stem on a metal stamp or perhaps under the gear shifter I am unsure

tbrat44

  • 86 Answers
  • Posted on May 07, 2009

SOURCE: 04 yfz 450 wont start with electrical start

i have a 04 yfz 450 quad. the compression ratio like yours is extremely high. ive had my battery go bad and found that another battery other than factory would turn over the engine, but would not start. i paid the 100 dollars for the factory battery and it fired right up. because of the high compression you need a high cranking battery.

tombones

  • 3567 Answers
  • Posted on Sep 06, 2009

SOURCE: carburetor adjustments yamaha 450yfz 2004

Turn both the air screw and throttle screw inward until they LIGHTLY seat. Now back each one outward one and one half turns. This is the factory setting. I am going to give you a web site where you can download a free PDF factory service manual for a YZ450FR. I believe the model is a bit different but the carbs are the same.

Go to this site and you can download a free PDF service manual. The site may take up to 25 seconds to fully load the list of manuals. It is worth the wait. www.carlsalter.com/motorcycle-manuals.asp The service procedures are there in detail and a lot of diagrams and photos. Don't mess with the pilot screw unless you have to, Part #11 in the diagram.
Can I get a Very Helpful" rating out of this?

6a23d75.gif

mxtras

mxtras

  • 194 Answers
  • Posted on Nov 25, 2009

SOURCE: how do i remove and clean the carburetor on a 2005

The easiest way is to remove the seat and then remove the entire rear sub-frame - the airbox is attached to the subframe, so it will go with the subframe. Loosen the rear clamp on the intake boot. The sub-frame is only held on by three bolts so it's a piece of cake to remove.

Once the subframe is off, the carb will be wide open and easy to remove from there.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2004 YAMAHA YFZ 450 Quad POPS OVERHEATS BREAKS UP AT HIGH RPM.

Question edited for full 'year make model (what it is).
Question moved from motorcycles to make model category.
Please don't type in all CAPS, it is considered SHOUTING and is harder to read.

'clips' and 'turns' it took me a while to realise you were talking about the carburetor and you were playing with the mixture screw and needle position! 4 turns out is a lot different to the factory setting which is 1 1/2 turns out.

If it is overheating it is running too lean. As you changed the stator, also consider the ignition timing. Popping can also be caused by the ignition failing under load, coil, lead and spark plug.

Carburetor and tuning.

https://www.google.com/search?q=2004+yamaha+yfz+450+carburetor+adjustment

This carb has a LOT of jets!

https://www.amazon.ca/Carburetor-Rebuild-Yamaha-YFZ450-2004-2009/dp/B07JNYP667

....
0helpful
1answer
0helpful
1answer

I have a 2004 Yamaha YFZ 450 the bike will start and drive but as soon as it warms up when you push the throttle it starts to cut out... What is the problem?

There is not really enough info in your post to narrow down the problem. Hesitation during acceleration can either be fuel related or ignition timing related. Once up to speed, will it maintain that speed smoothly?

If you have a timing light, check the timing at idle. If it is OK, then it is probably fuel related.

Assuming you have not messed with the ignition timing, if it idles, but won't accelerate, it is probably starved for fuel. 1.Check/change the fuel filter- easy and cheap
2. pull the fuel line off the carb, and make sure fuel flows from the tank freely.
3. If there is good fuel flow to the carbs, pull the carbs and clean them.
0helpful
1answer

My 2004 yfz 450 wont start i changed plug and stator still wont start you can hear lil backfire from pipe when trying to crank

Hi,
Did you tried replacing the CDi for your bike?
Tell me what happen when you replace or borrow a CDi from your friend, just to check if it is the real culprit......
0helpful
1answer

How do i get my idle down on yamaha yfz 450 quad

Turn the idle screw anticlockwise half to one turn to set if this does not affect idle speed then you need to look further inside carbi or intake valves for other issues
0helpful
1answer

I have 04 yfz 450 and its overheating.I start it let it idle for 5mins and its overheating I no the coolant is circulating there is no water in the oil

Headgasket leak?If you have not done so already try filling up the rad(when cold) and run the engine with the rad cap off and look for air bubbles, or you could go to a radiator service centre to check for carbon monoxide in the rad.

Please get back to me if you require further asssistance.
0helpful
1answer

My starter will not engage but all my lights work nuetral light headlights etc, but if i put it in gear and rock it back and forth (sometimes longer then others) and put it back in nuetral i can get the...

IF YOU CAN HEAR THE STARER TRYING TO ENGAGE BUT WONT THEN YOU MOVE THE FLY WHEEL BY ROCKING THE BIKE AND IT WILL YOU HAVE BAD TEETH ON EITHER THE FLYWHEEL OR THE STARTER
3helpful
1answer

Timing on 06 yamaha yfz 450

Here is the SERVICE MANUAL for your bike.

http://pdfdatabase.com/download_file_i.php?file=14074911&desc=Yamaha+YZ450F+Service+Manual+.pdf
0helpful
1answer

04 yfz 450 wont start with electrical start

i have a 04 yfz 450 quad. the compression ratio like yours is extremely high. ive had my battery go bad and found that another battery other than factory would turn over the engine, but would not start. i paid the 100 dollars for the factory battery and it fired right up. because of the high compression you need a high cranking battery.
Not finding what you are looking for?

669 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...