Horn/head/tail lights work. Just bought & don't have wiring diagram.
The problem is that your flasher relay has burnt out. You can locate this by simply flowing the wires from the turn signals.
I may have had the same problem. Last summer I fnd at times my Headlight would intermittently go out usually after riding over a bump or just after starting the enging. I later found that the starter button was jiggling around inside its recess making intitial contact with the posts causing the headlights to go (as they should when normally starting the engine). To check, pull the start button out while it's running and check the operation of all the lights.
TAIL LIGHT NOT WORKING
It
can be faulty tail light bulb or its issue with tail light control
switch or its wiring's are short.
Check the voltage at fuse slot of tail light.Do you receive 12 volt
there.If not,then it says tail light switch is not receiving power supply.
---------
There
are few help links related to your problem.I suggest you refer the list and
check the help links.Click the link below:-----
----------
http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html
--------
http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html
-----------
http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html
-----------
SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html
----------
http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html
-----------
--------
---------
----------
http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html
----------
These details will help.
Thanks.
434 views
Usually answered in minutes!
×