I had someone replace my transmission on my truck and he broke the vacume line that runs from the transfer case to some where in the back of the moter, i'm looking for a diagram so i can figure ou

I found the lines and the go up from the tranfer case to somewhere in the back of the motor by the distribitor by it so tight in there i cant see anything

4 more comments
Anonymous Apr 12, 2013

1997 dodge ram 1500 4x4 this is a hard plastic vacume line from the transfer case to somewhere behind the motor by the firewall
Todd Arndt Apr 12, 2013

Does your Transfer Case shift Manually from the Floor? There is no Vacuum Line on the Transfer Case, it is a Vent Hose... Transmission and Transfer Case use them to allow the Components to breath and not build up pressure...
Anonymous Apr 12, 2013

manual shift on the floor and YES my transfer case has 4 vacume lines coming out of it, 2 go to the switch on the front axle and 2 go somewhere behind the motor bt the firewall
Todd Arndt Apr 12, 2013

That is different than my 2000 Ram 1500, I am sorry that I can not assist you any further at this point, I am not experienced with a Vacuum Controlled Transfer Case... the old 1980's Chevy used them but no longer... Good Luck in finding the information you are seeking.
Anonymous Apr 13, 2013

The last time I inadvertently on the website ,and see this website ,this web selling bags,shoes inside very cheap. the bags and shoes are very beautiful. Now share for everyone .http://www.pokostyle.com .
Anonymous Apr 13, 2013

im not looking for spam! im looking for answers about my truck!

1 Answer

Todd Arndt

Cars & Trucks Master 2,044 Answers
Posted on Apr 12, 2013

Todd Arndt

Cars & Trucks Master

Joined: Jan 18, 2008

Answers

2044

Questions

Helped

584537

Points

5934

I think what you are looking at is a VENT TUBE and not a VACCUUM TUBE

What is the YEAR/MAKE/MODEL of your Truck?

Chevy 4L60E ?

2 Related Answers

ZJ Limited

17989 Answers
Posted on Jan 07, 2010

SOURCE: looking for a vacum line diagram so i can print it 1996 gmc jimmy

GMC S10/S15/Sonoma Pick-Ups 1982-1993 Repair Manual
VACUUM DIAGRAMS (See Figures 1 through 85)

Below is a listing of vacuum diagrams for most of the engine and emissions package combinations covered by this manual. Because vacuum circuits will vary based on various engine and vehicle options, always refer first to the vehicle emission control information label, if present. Should the label be missing, or should vehicle be equipped with a different engine from the car's original equipment, refer to the diagrams below for the same or similar configuration.
Check the link autozone.com (free register), select the year ('91 sample), Brand, Model, Sub-Model, Engine Size and make the next root...
1991 GMC TRUCK S15 4WD 4.3L TBI 6CYL REPAIR GUIDE >> EMISSION CONTROLS >> VACUUM DIAGRAMS

I really hope helps with this (remember rated this help). Good luck.

Harvey N Tawatao

3854 Answers
Posted on Mar 17, 2010

SOURCE: 2003 Sierra 2500hd transmission or transfer case

Sudden grinding noise with no prior warning * Primarily in 2nd gear, behavior in reverse may be abnormal; sunshell is fractured. R&R. Try not to run or drive the car or further damage could result.

* Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either. R&R sooner rather than later.

* Either a torrington bearing or a planetary bearing is on its way out. Trans will eventually die a loud, catastrophic death. Cheaper to rebuild now (saves further damage to hard parts), but requires R&R. It is drivable until it breaks.

Good luck and thank you for using fixya.

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

Found oil in vacum lines replaced some parts on trans blew out lines

Is this a 4x4? If so, vacuum switch on top of the transfer case and any HVAC parts that are damaged. That might be the part they replaced for you. Is there a hiss coming from the dash controls? If so, you will need to replace the mode switch with one from a junkyard. Otherwise you have to buy the whole control unit. I think it's about $65 bucks from Amazon. Probably $165 from the dealer. Here is some info on an older truck in the link. GMC Sonoma Chevy 10 Transfer Case Vacuum Switch

Read full answer

Jun 20, 2014 • 2002 Chevrolet S-10

0helpful

1answer

2004 ford f150 4 wheel drive doesnt work

If your truck has Vacume actuated hubs check the vacume lines running to the hubs right behind the brake rotor. If it has the electronic actuated hubs, check connectors / and or replace actuator motor on the front diff. Also possible Transfer case motor seized if you have push button 4x4

Read full answer

Mar 15, 2011 • 2004 Ford F150

0helpful

1answer

My 1985 chev blazer will not engage the front drive axel. I had the transmission replaced and i now have unconnected vaccume lines around transfer case/transmission area. Is there a valve or something...

if the light for 4wd does not come on it could be that a vacume line has cracked or become seperated from the ball under your battery listen under hood for a hiss, my hisses usually come from somewhere around the heater box where the lines join together on the way to the ball or the vacume ball may be bad the front wheels will not enguage without vacume applied as vacume pulls the locks in. The xfer case is working if it turns the short driveshaft

Read full answer

Nov 08, 2010 • 1985 Chevrolet S-10 Blazer

0helpful

1answer

FOUR WHEEL DRIVE DOSENT WORK VACUME LINE BROKE BUT CANT FIND WHERE IT GOES

the hose should be a vent to the axle, the axle should be live all the time and power is transfered by the transfer case, the 4x4 function is controled by an electric motor on the case, I would check fuses, but after that I woould recommend a shop look at it!

Read full answer

Apr 08, 2010 • 1999 Ford Explorer

1helpful

1answer

4 wheel drive does not work. All vacume lines are

May need to replace the switch itself. Most new vehcile are all electronically engaged. Replace the switch. Cheap fix compared to going into the transfer case first.

Read full answer

Oct 10, 2009 • 2000 Kia Sportage

3helpful

2answers

I have a 1996 Dodge Ram 1500 quad cab 4x4. I have been in Iraq for 15 months, and now that I'm back I went out to test the truck out. when trying to switch into 4 high, nothing happens, no "jump",...

Most likly cause to your problem would be the transfer case vacume switch check for vacume at switch then check for vacume at the front differntal if you have vacume at switch but none at the front differntal then replace transfer case vacume switch if no vacume at switch look for broken vacume line at intake manifold

Read full answer

Sep 17, 2009 • 1996 Dodge Ram 1500 Club Cab

1helpful

1answer

1993 Chevy Blazer Mileage scrambled and 4 hi not working.

ok well its hard to do without seeing it. but here goes. if it has electronic dash then it sounds like you either have a faulty conection on you wires to it or your cluster is fubared. best way is if ya have a friend with the same truck swap out and see if that helps. if ya dont have a buddy with one then check your wires on the back of the gauages. might have some corrotion on the little brass whire inlets on the clusters. if that doesnt work ya prob need new cluster. as for the 4x4 will sounds like an intermitten problem.if ya have a good seal on your actuator on the top of the transfer case check the vacume lines that run to it for vacume.one will have vacume. does your truck run a little ruff when on idol? sounds like a vacume leak of some sort. it isnt the transfer case because it did work so it must be something to do with the vacume. take out acutaor again on the transfer case and watch as someone puts in 4 hi and 4 low ya should see the ball bearing on the bottom go up and down.has the truck been sitting for awhile? sometimes the transfer case gets sticky without being used offten. make sure your fluid level is up. there will be a bolt on the top side of transfer case that will alow you to feel for fluid. check with pinky. if you can feel the fluid it is up.might be best to replace fluid. hope that helps. if ya need to get better info add [email protected] on messenger and i will talk ya through it. hope this helps. i know these trucks very well. hope this helps!

Read full answer

Dec 22, 2008 • 1993 Chevrolet S-10 Blazer

0helpful

2answers

Push button 4wd wont engage in 4wd

there is a small sensor on the top of the transfer case that has three vacume lines into it. that little switch has a bearing that the vacume sucks up to operate the 4 wheel drive. replace as well as check the vacume lines to make sure you dont have a hole or leak in them

Read full answer

Dec 12, 2008 • 1999 Chevrolet Silverado 1500

0helpful

1answer

4 wheel dive wont work

its a vacume operated cylinoid on the top of your transfer case. has three vacume lines to it. replace. could also be your vacume lines to that switch. check usally they touch the exhaust manifold and put a hole in it check that as well.

Read full answer

Dec 07, 2008 • 1994 Chevrolet S-10 Blazer

0helpful

1answer

I have a 2001 Chevy Tahoe 4x4. I changed from 2Hi to 4Lo and now can not get it to change to anything else, nor will the transmission shift out.

small cylinoid on top of transfer case is stuck. vacume operated. replace or check vacume lines to the switch. three lines

Read full answer

Dec 06, 2008 • 2001 Chevrolet Tahoe

Not finding what you are looking for?

View Most Popular

Cars & Trucks

Found oil in vacum lines replaced some parts on trans blew out lines

2002 Chevrolet S-10

79 views

Ask a Question

Usually answered in minutes!

Related Topics:

I had someone replace my transmission on my truck and he broke the vacume line that runs from the transfer case to some where in the back of the moter, i'm looking for a diagram so i can figure ou