Speedo doesn't work changed speedo , changed speed sensor, changed tsm, checked all wires to the speedo from sensor all wires from speedo to tsm for continueity checked out fine, checked all grounds and bettery connections
SOURCE: 1985 honda v65 sabre has speedo needle stuck on 35
Check for bad fuse holder spring contacts. Loss of power to speedo or sensor will cause this problem as V65 Sabre uses stepper motor for speedo.
SOURCE: 2004 FLHTCUI ULTRA CLASSIC..TRYING TO WIRE UP FOR
chk backwards to your turn signal control unit. The brake lights and rurn signals are routed in a way that would affect each other.Is this a four wire or?Chk fuses 1st. Good Luck- -Ned- A good grd is important.
SOURCE: suzuki vl 800 speedo dont work.
Have you had your front wheel off at any time?
What usually happens is the magnetic speed sensor at the front wheel was
not lined up properly when the wheel was replace and it broke. A very
common occurrence.
SOURCE: bike 2002 dyna wideglide speeo
First of all electrical problems on these bikes are hard to diagnose, especially on the computer. I assume you checked all your fuses and wires for any obvious shorts or blown fuses. Sounds like a wire might have melted in the heat and shorted out.Check the wiring from your ECM to the speedo under the gas tank and around the motor to make sure nothing shorted out.
Then if nothing found there is the Speed sensor located on top of the transmission. Remove, clean all debris off of it and reinstall. If that doesn't correct the issue, the sensor may need to be replaced.
SOURCE: I broke the speedo of
Normally the speedo will have to be set up for your wheel/tyre size and I assume that information would be supplied whaen you purchased the unit.
Send the supplier an email asking for guidance.
484 views
Usually answered in minutes!
×