I have a 4 pole flat trailer light wire harness already. I need to change to a 5 pole flat connector . The new pole will tie into the reverse light wiring which will energize a solenoid that releases the surge brakes on my boat trailer so that I can back up. What is the easiest way to get to this wire and what color is it?
We at not living in the 1960's
You tap into any of today's vehicle circuits, your
asking for unknown problems
Have you considered you said a solenoid,& do you
know the current draw on that solenoid
Best design a new circuit using a relay & control it with
the back up switch ,if the can handle the extra current
Need wiring diagrams,some math & ohm's law there
SOURCE: Need help with 2004 Hyundai Santa Fe Audio Wiring
Sounds like you need a light tester. I would guess that at least 8 of the wires are speaker + & - the others will be Main power and earth Possibly electric ariel, Memory store and a wire for the anti theft circuit. Assuming the stereo is factory. Any Audio shop can perform a test to clarify the purpose of the wires Wouldnt worry about the blank its probably a position for a newer or different model to yours. Steve in the UK
SOURCE: Im trying to connect my pioneer radio to my
Radio Constant Wire 12V+: Red
Radio Ignition Switched Wire 12V+: Yellow
Radio Ground Wire: Black
Radio Illumination Wire: Pink/Black
Radio Dimmer Wire: n/a
Radio Antenna Trigger Wire: n/a
Factory Amplifier Turn On Wire: n/a
Left Front Speaker Wire (+): White
Left Front Speaker Wire (-): Brown
Right Front Speaker Wire (+): Black
Right Front Speaker Wire (-): Yellow
Left Rear Speaker Wire (+): Blue
Left Rear Speaker Wire (-): Red
Right Rear Speaker Wire (+): Green
Right Rear Speaker Wire (-): Orange
SOURCE: electronic connector for brakes on Hyundai Accent
hi from uk the part you mention is the brake stop light switch it has a plug on 2xwire plug it operates by as pedal is pressed the plunger of switch moves out and connects the 2xwire circuit and so brake lights operate this switch simply unscrews from the pedal box/carriage after plug removed then the new switch screwed in place and with b/pedal off the switch is screwed to a point that if you press pedal down approx 1/2 " the switch plunger moves out and b/lights come on this is trial/error untill you are happy with the pedal movement down till lights operate SIMPLE ! hope this helps?
Testimonial: "thanks for the feedback, now all i need to find out is if I can buy this part? "
SOURCE: brake lights don't work
This sounds like a bad brake light switch, this switch is located on the bracket that holds brake pedal,you can test for power at switch,also if you remove connector and jump terminals with a wire and see if lights lite, if lights light then switch is bad,
SOURCE: My daughters hyundai accent 2000
Do the blinkers work? If the same bulbs work as brake lights also work as blinkers, the wires for them are routed through the turn signal switch. If that switch is bad, you won't have brake lights.
536 views
Usually answered in minutes!
×