Kickstart aint working.... how do i fix this?

Will the bike start when you bump start it? If it does, then you will need to replace the kickstart drive gear.

Rock the bike gently forward and back while shifting into fifth gear. Now push the bike forward while sitting on it and see if the rear tire turning will turn the motor. If not, your motor is stuck. If it turns, you have a kickstarter issue.
Many people never learned to depress the kickstarter down until you feel it engage before kicking it through. Kicking from the top slams the gear teeth together and causes damage. You may need to pull of the engine cover to determine if there’s damage.

check pawl spring on kickstart lever.

have a look at the clutch cable there may be far to much slack on it so your not fully disengaging the clutch thats why the bike pulls forwards

sounds like you have something lose or broken in gearbox..or clutch or kickstart workings.....i would not ride this bike till you know for sure whats up & its fixed!!....1st thing to try is take clutch cover off & inspect to see if you can see anything broke ..this does need pulling down to sort as the bike may well do again when riding it...you may even need to pull the gearbox.cluster out/in bits to check..this means engine out & pull in bits......

they just sound like wires for the lights speedo ect.not why bike aint running.

Sounds like a broken kickstart mechanism or spring. Youll have to take it apart to find the damage
Ride Safe
Bike-doc

Please mark this as useful (if it has been!!)

First thing to do is make sure it's the kick starter that has seized and not the engine. Take the cover off the end of the crankcase and try to turn the crankshaft. Apparently these engines were notorious for doing bottom ends. Start pulling it down and see what you find..

this could be really bad or really easy. first, lets hope its vapor lock. take your spark plug out and see if it will turn. if yes, kick it a few times and replace spark plug. if not then we need to see if the kickstarts malfunctioning or the motors lock. put the bike in about third gear, grab the clutch and pull it in, now run beside and push the bike with the clutch in, get some speed and dump the clutch. Hopefully the engine will start turning over, in fact if you have the switchs on you can start the bike this way. If the engine does not turn over like that then you have a drivetrain problem, without seeing the bike theres no way to pinpoint it. Lets just hope the steps above work and you dont have any major problems, good luck.