2008 KTM 250 SX-F Logo

Related Topics:

A
Anonymous Posted on Sep 24, 2012

2011 ktm250 sxf wont start

Was running the back fired and stopped running . will not start now

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Dec 15, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Dec 15, 2012
Answers
1
Questions
1
Helped
773
Points
1

I have a 2009 ktm 450 sxf and was riding yesterday and it stalled out when i switched to fourth gear and wont start back. battery is good and when i hit the e start it just clicks once, and it wont roll start either. any suggestions? could it be the switch under the tank? PLEASE HELP!

3 Related Answers

Anonymous

  • 52 Answers
  • Posted on Jun 06, 2009

SOURCE: i av a ktm250 04 sx it only runs for 2t3mins then

http://justkdx.dirtrider.net/floatlevel.html

check the float needle its a common problem.

Ad

Anonymous

  • 41 Answers
  • Posted on Oct 04, 2010

SOURCE: When I stall my ktm 450 sxf it wont fire again

Your gonna seize your engine if you keep stalling it, very bad. Also its a switch that incase you crash and the engine stalls it will cut power to the coils located under the tank, to prevent any kind of electrical fire. just don't keep stallin it and let off the clutch just a little slower.

raj somaiya

  • 5370 Answers
  • Posted on Aug 13, 2011

SOURCE: 2011, 250 sxf. starts first

The main box fuses and relays needs to be inspected for short and wiring's needs to be inspected.Also injectors needs to be tested , may be injectors are worn or getting blocked. agree injectors and other electrical parts already, tested, but get it tested by meter.Also get compression test for each cylinder.Also test flow of fuel, is the fuel flow getting low after start up.If the pressure is low , then fuel will not reach to engine as required and engine will stop, this will cause bike to stop.--------- Getting this possibilities checked will help.Thanks.Helpmech.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2011 yamaha rhino will fire and run only while your cranking engine will stop when let the key off start position

Sounds like you losing power in run position. Check ignition switch to be sure power is staying on in run position.
0helpful
1answer

Ktm 450 2011 wont start up electrical problem?

Check the coils if it is fine change sparks plugs should solve the problem
0helpful
1answer

Starting Problems Ktm 450 sxf

It's your batt....... simple. The last three replys are the stupidest things I have ever heard!!.
0helpful
1answer

2011 KTM 250 SXF valve clearance

.010" inlet hot .012" exhaust hot if water cooled
if air cooled add .002" to the measurements
0helpful
1answer

2011 250 sxf . owned for 8 months bought new.problem is the bike will die as soon as you give it gas.problem is very intermitent. may run great for a while then will start doing it again. been to dealer 6...

When you "give it gas" you are opening the throttle.
At that point the fuel system is supposed to supply the engine with more fuel to maintain the air/fuel mixture.
Check for anything that might be clogged like filters, hoses, fuel passages, etc.
If it is still under warranty you could void your warranty
if you work on it though in this case a warranty is meaningless if you have taken it in 6 times.
I've seen models where you could replace everything and
a week later it would refuse to run.
Sometimes it's better to leave the thing at the junk yard and buy a new one but that doesn't happen often.
0helpful
1answer

When I stall my ktm 450 sxf it wont fire again however if u turn it off at the ignition it starts straight away?? What could this be?

Your gonna seize your engine if you keep stalling it, very bad. Also its a switch that incase you crash and the engine stalls it will cut power to the coils located under the tank, to prevent any kind of electrical fire. just don't keep stallin it and let off the clutch just a little slower.
0helpful
1answer
Not finding what you are looking for?

783 views

Ask a Question

Usually answered in minutes!

Top KTM Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...