SOURCE: harley davidson flstc heritage softail 1997
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
SOURCE: what is top speed for a 1999 heritage flstc harley
Why want to know, you won't be able to reach it anyway. Over 180 kph. Rule of thumb, if speedo say 200 then abt 10% below it on prime conditions.
SOURCE: need to know if there
To remove the starter on you Softail, first disconnect the negative side of the battery.
Then drain the primary and remove any footboards, shifters, ect. so that you can get the outer primary cover off. Once the cover is off, remove the small bolt that holds the starter jackshaft on and remove the jackshaft. The jackshaft coupling may come out with the jackshaft. Mark which way the coupling goes back in as there is a snap ring on the inside that is not in the center.
Now, go to the right side of the bike and remove the exhaust system, and remove the bolts that hold the oil in. Do not take the tank out but you need to be able to lift the tank just a bit. Remove the battery cable from the starter using a 12mm wrench. There are two large bolts that hold the starter into the inner primary, remove these two bolts and unplug the small wire at the top of the solenoid and the starter will come out.
Good Luck
Steve
SOURCE: will a Fat Boy rear wheel fit on a 2002 Harley Davidson FLSTC - FLSTCI Heritage Classic
Duplicate question already answered
864 views
Usually answered in minutes!
×