SOURCE: blinkers dont work
The problem is in the TSSM (Turn Signal Security Module).It has a Bank Angle Sensor in it that shuts the bike down in case of an accident it will shut down when the bike is knocked over.It should have reset.You might be able to disconnect the battery and reset it but you will probably have to take it ti the dealer to have it fixed electronically.
SOURCE: Tanked up at gas station.
For speedometer not working replace the speed sensor
the speedo sensor mounted on the transmission. They have a
habit of going bad. Sometimes it is possible to just clean metal particles off
the magnectic tip and it will start working. speed sensor (vss).The vss gets metal shavings on it from the trans.You can clean it off but take a few more minutes and replace it.Replacing the speed sensor should help.------
The speedo wires are white,,red and black.If the speedo is not working the sensor may be bad.Its located in the top of the transmission
-----------
This should help.Thanks.Helpmech.
Not necessarily a bare wire. Could just be a slight broken spot in the insulation. Check the wiring inside the rear fender. Sometimes the tire gets into the wiring harness and chews things up a bit. This usually happens on lowered bikes.
835 views
Usually answered in minutes!
×