Need a wiring diagram for a barbie 12 volt two battery jeep !!!!!

It may be a failed switch or little broken wire.

Test the charger with a ohm meter, or you could take the vehicle to a Power Wheels service station, they can test the battery for you to see if it is good.



You can find your closest service center here: http://service.mattel.com/us/powerwheels_info.asp

If you end up needing a replacement battery or charger they can be found here: http://www.mendingshed.com/powwheelbat.html

Let us know if you need any more help.

Thank you,

Colleen
Customer Service
MendingShed.com
800-339-9297

the radio runs off of a seperate battery source, so that wouldn't have any effect on this, i would first of all check the battery and charger with a multimeter and make sure that they are showing the correct voltage, if its a 12v battery make sure that they are showing at least 12 volts, if its a 6v battery make sure that its showing at least 6v

Hi,
You have to push the horn to make it go. I had same problem. Gave to hubby to look at, He had it going in minutes.

Yes they should work if uou inserted everything correctly. I would suggest using different ebay links, one specifically..

Vintage Lot of 6 1965 Mattel Mattel-O-Phone Records Toy Collectibles Vintage Set of 6 Mattel-O-Phone Records by Mattel. 5 records are dated 1965 & 1 is dated 1967. Records include...Barbie, Talky Toys, Familiar Friend
mybookbarn.ecrater.com/p/6503772/vintage-lot-of-6-1965-mattel-o-phone-records · Cached page

Vintage BARBIE Mattel O Phone RECORD GC telephone ' eBay

• Seller 100.0% positive ·
• Free shipping ·
• Shelbyville, Tennessee

Dolls & Bears > Dolls > Barbie Vintage (Pre-1973) > Vintage (Pre-1967) ... Vintage BARBIE Mattel O Phone RECORD GC telephone
cgi.ebay.com/Vintage-BARBIE-Mattel-O-Phone-RECORD-GC-telephone-/150549739745?pt=LH... · Cached page

I know you are technically strong to do the bypassing part. But assumption is to do with fuse.

Your Power Wheels® 12 volt battery is equipped with a built-in thermal fuse. The thermal fuse is
a self-resetting safety device which automatically "trips" and shuts down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe. Once a fuse has "tripped", remove your foot from the pedal and wait approximately 25 seconds before operating the vehicle again. To avoid repeated automatic shut-downs, avoid severe driving conditions.

better call up Fisher price, and lay back with free mind.

http://www.amazon.com/Volt-Nitro-700mAh-Battery-Charger/dp/B00002SU0V
Here you can buy that battery for your grandson and let his dino roar!

Assuming that you want a 12 volt equivalent, you should wire the batteries as in the following diagram.
If you are looking for some other configuration, post a reply.

You can get the replacement battery on link below.

http://www.walmart.com/ip/Fisher-Price-Power-Wheels-Long-Ride-12-Volt-Battery/882948

http://www.amazon.com/Fisher-Wheels-12-Volt-Rechargeable-Battery/dp/B00004TFT1

Good luck and please rate 4 thumbs for the free answer.

It has a thermal fuse. Depress the gas pedal for 25 seconds and try it then