It almost sounds like it is gonna start when i try to pop start it
SOURCE: FOR Yamaha XF50 model Yamaha c3 scooter stolen ignition wires cut
Just pick up some wire connector unions with some shrink wrap.,Identify first the identical matching wire colors (each wire will have a color, example: red with a white strip connects to the other red with white strip etc.) do this to all the wires being sure to slide a length of shrink tube up over one side of the wire before crimping the connector with the two ajoining wires together then slide the tube over the wire crimp connector and use a lighter or heat gun to heat the rubber shrink tube to seal the connector. Do this to all the cut wires one at a time until all are joined together withe union crimping connector method. Be sure you positively identify the color of the wire and its backround stripe color along with the other identical wire that it needs to connect to, you don't want to hook the wires up wrong it could burn something out be caareful and positive the color patterns on the wires to be unioned are identical if you do you will be alright in this job.
Hello
When the service engine
soon light (Also called the check engine light or engine management
light) is turned on this is to alert you to the fact that Powertrain
Control Module (computer) has detected a failure somewhere in the
systems it controls you may not feel any difference in the way the
engine runs, this can be the transmission or the engine or emission
system, there are fault codes set in the modules memory for these
faults. What needs to happen now is to have the powertrain control
module scanned with a special tool called an OBD2 electronic engine
control scanner or a OBD2 code reader. Once the code(s) are read then
you must perform the diagnostics for each code and make the
appropriate repairs based on the findings of the diagnosis that was
performed, this is called doing "Pinpoint" testing.
52 views
Usually answered in minutes!
×