2006 Harley Davidson FLSTFI Fat Boy relocate the front turn signals @

SOURCE: front turn signal relocation on 2009 HD crossbones

easy job , takes about twenty mins or an hour for perfection. instrutions are good in the pack from jp.but here goes ; remove each light from bars using allen key ,cut wire at about 4" from indicator, remove dog bone from indicator and fit new bracket and bolt , tighten to the point that you can twist the light if you have to for leveling them when finished,next remove lower fork bolt and install light complete with new bracket on to fork with new longer bolt tighten to spec. same sequence for other side .now you have the job of reconnecting the wireing with crimps and heat shink sleaving.if you still need a picture pls email [email protected]

SOURCE: i have to relocate the rear turn signals on my

HD has a relocation kit available for this...JP Cycles should have it as well. The kit comes with instructions on how to do it.

SOURCE: fork oil do I need in each on a fatboy

ten ounces in each side . Make sure they are drained completely to avoud overfill

SOURCE: relocating front turn signals on 2009 Fat Boy

front turn signal wires should be routed down the right side of the backbone of the frame under the gas tank. they will be violet and brown wires along with 2 blacks for grounds.

SOURCE: removing stock rear turn signals on 2006 Harley Davidon 1200

I have not removed the turn signals from a model this late. There may be a nut between the fender and the fender strut. You may have to remove the fender to get the turn signals off.