2005 Qianjiang QJ125-J Logo

Related Topics:

Anonymous Posted on Nov 10, 2008

Tires what to look for while checking the tires?

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 2,336 Answers
  • Posted on Nov 10, 2008
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Jul 01, 2008
Answers
2336
Questions
37
Helped
756769
Points
8022

Under well-lit conditions look for any signs of punctures (such as nails or shards of glass) which might potentially lead to a loss of pressure or a blowout. Bulging or cracking might also occur on old tires; make sure you roll your bike forward in order to see all surface areas that come in contact with the road.,

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3helpful
2answers

Does the service tire monitoring system cause the check engin light to come on

sound like two problems service tire light and check engine light.have vechicle code scan and put air in all four tires make sure put correct amount air pressure in all four tires.
0helpful
1answer

Tire pressure

every different vehicle and different tire has a (correct) tire pressure for that particular application.check your drivers door sticker or plate for tire size and pressure and then check your actual tires sidewall for the tires specified pressure. the vehicle sticker (Usually) takes presidence.
1helpful
3answers
0helpful
2answers

The check tire pressure light is on. I check the

Check that all your tires are inflated to the specification recommended by the vehicle manufacturer or higher. There is no TPMS warning for "overinflated" tires, because there is far less danger per NHTSA studies than "underinflated" tires.

You can safely inflate your tires to the max pressure rating on the sidewall. The pressure listed by your vehicle manufacturer is a compromise between noise, tire life, and ride comfort.

Try installing more air, up to 35 PSI, and see if the light goes out. If it does not, you may have a faulty TPMS sensor, which is inside the tire, attached to the tire valve. This will require a qualified service technician to further diagnose and repair.
2helpful
4answers

Tire wear in middle of both rear tires

problem is with over inflating the tires,causing middle tread wear,as long as you have more the 3/32 tread wear in the middle than you are ok.always set tire pressure when cold at around 33psi,check tire inflation sticker on dar jam for exact tire pressure
2helpful
6answers

Tire pressure

Seance the car manufactures most likely did not produce the tires that are on the vehicle they will only give there recommendations as to the correct tire pressure. Always look around the perimeter of the tire and it will tell you the proper pressure for that tire. hope this helps. Good luck.
0helpful
1answer

Toyota Sequoia low tire indicator light will not go out.

Make sure when you check tire pressure you also check the spare tire. It also has a pressure sensor on it.
3helpful
3answers

Tire pressure sign

Check the spare tire...The spare tire is also checked by the tire pressure warning system. Once the spare is inflated to the proper pressure, the light will go out.
20helpful
1answer

Tire reset on in ford freestar

Reset without message center:
To reset turn the ignition to the ON position, depress and Trip/odometer
button (located in the instrument cluster) until “TIRE RESET” or
“CHECK TIRE AND RESET” is displayed in the odometer display window.
Once “TIRE RESET” or “CHECK TIRE AND RESET” is displayed,
press and hold the button for three seconds. The low tire warning indicator light will flash three times
as the low tire warning system begins to initialize.

------------------------------------------------------------------------
Reset with message center:
To reset turn the ignition to the ON position, press the set up button on
the message center until “SYSTEM CHECK” is displayed. Press the
RESET button until “HOLD RESET TO RELEARN” is displayed, continue to hold the button for three
seconds. The low tire warning indicator light will flash three times as the low tire warning system begins to initialize.
Not finding what you are looking for?

37 views

Ask a Question

Usually answered in minutes!

Top Qianjiang Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Are you a Qianjiang Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...