I have fuel and power. I shot startinf fluid and it started. does anyone have any ideas
SOURCE: 1990 yamaha virago 535 sat two years
If it is possible to start at all. Fresh fuel fresh engine oil good battery. You may have the following problems; Corroded and blocked carburetor fuel system, bad wire connections piston ring set up.... I hope it was kept indoors and the fuel was drained out before it was left sitting. Good luck, they are nice bikes.
SOURCE: 1990 Yamaha Virago 535 Parts interchangeable with 2001 virago 250
Sure mirrors, nuts, bolts and screws. Maybe a fender and a bit of other stuff. But for the most part not much will match up and now you have this ugly monster in your garage and your next job is to figure out exactly how you are going to get rid of the da-- thing. Look a bit harder and get a match for your bike. Now you have something worthwhile.
A “very helpful” rating for this answer? Thanks!
SOURCE: im working on a 1996 535 yamaha virago. when i
Do you hear spark arcing on both? If so might be norm.
SOURCE: yamaha virago 535 turn ignition on neutral light
These are known for starter problems... The clicking you hear is the relay but the bendix is locked up put it in about 3rd gear and rock it hard forward and back. Bendix may release. Make sure battery is good. As I said before these bike are well known for their starter problem and even after having it fixed by a dealer problem seems to show back up after a very short time. Good Luck!
SOURCE: Virago 535 not starting
Sounds like:
A: The starter clutch is slipping and not letting the starter engage the crankshaft
B. The carbs need to be cleaned. If ti has sat unused for more than 30 days, the pilot jets are clogged up causing it to stall (off choke) and be sluggish on acceleration off idle.
187 views
Usually answered in minutes!
×