When key is turn on the dash lights and all lights on bike work, turn signal, horn, battery is fully charged. When I push the start button nothing happens-no sound or nothing. Oil light and fuel light blink when I push the start button, but no clicking. Jump the selenoid, motor turns but will not start.
SOURCE: 2000 yamaha YZF 600r wouldnt start
i suspect the battery is problem.Also you may have an electric fuel pump that is acting up.
SOURCE: 1997 yamaha yzf 600r electrical problems
a jump box is nothing more then a battery with leads on it so where are you connecting it verses the new battery you put in the bike. that doesn't make since unless you are connecting the box right to the starter motor then it be constently running the motor untill you unhooked it. check all your fuses and examine all wire harnesses for damage, burns, or any mellting.
SOURCE: Yamaha YZF 1000 Starting Problems
sounds to me that it could be a faulty wire....it may not be grounded right. follow the negative wire from the battery.check it and make sure the insulation is not cut anywhere.check that the wire on top of the starter is good and tight also.
SOURCE: 97 YAMAHA YZF 1000,wont start itself after bike is warm
Have you checked the ground lead?
Make sure it is clean, it runs down and bolts to the top right hand side of the crank case.
Sometimes what happens is, that lead gets grime on it, oil or corrosion.. and it doesn't make good contact. The lights, spark ETC load the crank case and frame full of DC.. when you shut the bike off the dc cant flow through the starter so it won't turn over.
after a while the dc trickles out it will let the bike start again.
Hope thats it and it works for you, good luck!!
P.S. how is he liking his ace?? Awsome bike, I have had mine since 1999, and it not about to go anywhere!!
535 views
Usually answered in minutes!
×