1994 Chevrolet S-10 Logo
Posted on Sep 04, 2008

1994 s10 service engine soon light

I have a 1994 chevy s10 ive replaced the o2 sensor the idle air contol the throdle posission sensor and the light comes after i park it it idles a little high then the light goes on then if i take off again the light goes off and it drive fine and idles fine

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 12 Answers
  • Posted on Sep 04, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Aug 28, 2008
Answers
12
Questions
2
Helped
9772
Points
35

Have you had the truck scanned for codes? If so, what was the code, codes? Why did you replaced those listed parts. Can you hear any hissing noise coming from the engine or engine compartment?

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What are the probable causes of DTCs P0031, P0603, and P1148?

Clean out you idle air bypass valve with carb cleaner. P0031 air/fuel sensor 1 heater (B1)bank 1, p0603 engine control back up circuit,p1148 closed loop B1. Broken heater in upper O2 sensor is one if not all of your problems. Replace all of your O2 sensors & reset engine light.
2helpful
2answers

Service engine soon light is on showed p0160 replaced an checked for bad wiring to the mas air sensor still rough idle in gear n now want to shake when it shifts into overdrive it shakes

MOST LIKELY A BAD O2 SENSOR...Potential causes of an P0160 code include: Holes in exhaust near post cat o2 sensor Bad Bank 2, position 2, o2 sensor Wiring problem, melted harness, broken connectors, etc. Bad PCM
0helpful
1answer

Service engine soon light started flashing then started to idle erratically

It sounds like it could be the o2 sensors, the mass air flow sensor, or the idle air control valve, take the vehicle to your local auto parts store and have them connect their scanner and pull the codes.
0helpful
1answer

My service engine soon light is on in my 1988 s10 pickup 5 speed with an inline 4 I have replaced the TPS, MAP sensor, spark plugs, fuel filter it was idleing to low then it was idleing high from work then...

you need to have the fault code pulled to see what is acting up. you can throw alot of time and money into a vehicle by swapping parts. from the problem you desribed it sounds as if the o2 sensor is slow to switch and cuasing fuel control problems.
0helpful
2answers

1989 chevy s10 4.3L 4x4 (automatic)Truck idles and runs great when cold. As soon as it reaches operating temperature It acts like it's not getting enough fuel. It will have an erratic idle and when I...

Chances are you have an oxygen sensor problem. When the engine warms up, the engine computer moves from open loop operation to closed loop, and it then uses the O2 sensor readings to adjust the fuel. If the sensor(s) is contaminated, it will send a false reading to the computer causing this problem.
0helpful
1answer

I have a 96 k1500 chevy truck and have 4 codes that pop up on the check engine light randomly. Codes are ckp A signal intermitent, cmp out of range, idle contol rpm to high, O2 bank 1 sensor 1 insuficent...

O2 sensor cross talk bank to bank irregular, change 02 sensor(s).

Sounds like Idle air control sensor bad, All of your codes interact, I would start with 02 sensor.

I would locate a Tech II and run a diagnosis, eliminate guess work.
3helpful
2answers

1987 chevy S10 engine idle problem

relace the throtle air idle valve.The temp switch will allso cause this problem.
1helpful
1answer

90 chevy 5.7L k1500 failed emissions

COULD BE A VACUUM LEAK TAKE PROPANE TORCH AND LEAVE OFF PUT AROUND ALL VACUUM POINT WHERE YOU SUSPECT COULD POSSIBLY LEAK ENGINE SPEEDS UP THAT'S IT WORTH A SHOT BEFORE SPENDING MORE CASH
0helpful
2answers

1994 chevy blazer 4.3l feels like miss at idle only new cpi,egr,ignition.no vac leaks comp good tsb 4 crank sensor w/ spacer shim?

Just some quick checks: I'll assume you haven't received any error codes.
fuel filter,bad gas(water in the gas), indication of failing fuel pump(the 4.3 is notorious for its pump problems),dirty spark plugs, clogged fuel injectors, failed fuel injectors, MAF malfuntion(mass airflow sensor), I could go on...

anaanymous
0helpful
1answer

My "service engine soon" is on...

Does it ever go off? Or is it on as soon as you turn on the vehicle?
Not finding what you are looking for?

1,212 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...