20 Most Recent
2007 Yamaha Road Star Midnight Questions & Answers
How do you take a seat off of a 2007 yamaha
Turn yur key to the left,,,dont push in just turn...you may have to jiggle the seat at the tank to get it released...mine gets stuck,,,when you get it off try some wd40 on the latch..
Tire question
Bluing means the tires were properly brought up to temperature and run. Being street tires, they should be okay for a while but since you had track days, you may have shortened their lives considerably. Did you use tire warmers? Also, Michelins are great and progressive when new, but when they get old, they are not predictable at the limit. They'll grip and then let go without the same level of feedback you'll get from Dunlops or Bridgestones, in my experience. YMMV.
I race on Michelin Power Races now but still prefer Dunlops for better feedback.
2006 yamaha roadstar fuel light
These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electronicshelponline.blogspot.com/
Not getting gas carburetor
have you looked at where the carb is ? wots in front of it ? wots connected to it ? hows it held to the intake ? if youve answered these Questions then still dont know what to do then take it to a bike mechanic !!
The motorcycle will not start
I'm assuming that the wiring is intact - no shorted or cut wires - and the ignition key switch is fully operational.
The alternator or its regulator are failing so not enough power is delivered = the battery isn't sufficiently charged. The low voltage isn't strong enough to make the electronics from the dash function and when the bike is moving the voltage drops even lower so the lights aren't powered anymore.Check the voltages delivered by the alternator and the regulator and replace the faulty part.
My bike keeps cutting out
If its a 2 or 4 cyl....are you losing ignition on one or more cylinders? Sometimes the ignition components fail when they heat up, but test fine cold.
If your bike has pickup coils (located next to stator in left crankcase cover) test the resistance cold and then once it gets hot.
Not finding what you are looking for?