20 Most Recent
2002 Yamaha TW 200 Questions & Answers
What is the psi for compression
Anything over 100 to 110 psi should run. Anything from 120 to150 psi should be considered good . Remember the higher the PSI the higher the octane needed to run the machine. If you ride in the mountains, high octane can be hard to find.
I need instructions on how to adjust a carburador
Turn the throttle screw and air screw inward until they LIGHTLY seat. Now open each of them one and one half turns. This is the factory setting. Now set the desired idle speed and then adjust the air screw for the fastest idle speed at the current throttle screw setting. If now too fast, reset the throttle and then reset the air screw to match.
Yamaha tw200 clutch
hi buddy,
its time to change your clutch kit, here's the best one for your TW200
http://www.starcycle-usa.com/servlet/Detail?no=12114
1989 Yamaha trail way 200 no spark
Bike is 30yr. Ignition parts wear out. Spark wires wear from inside. The spark module or magnetic points cud b problm.Alsotiming may hav gottn out of wack from tightning chain-too much torque on loose internal stuf like the timing chain. Buy aclymer orhaynes shopbook
Not finding what you are looking for?