20 Most Recent
1989 Yamaha XV 535 Virago DX - Page 9 Questions & Answers
Yamaha yz 125 kickstart wont move
If the kickstart won't move and the bike won't go into gear, it's likely that there's an issue with the transmission or engine. Here are a few possibilities to consider:
- Seized engine: If the engine seized while you were riding, it could be preventing the kickstart from moving. This could be caused by a lack of oil, overheating, or other issues. If the engine is seized, you will likely need to replace it or have it rebuilt.
- Transmission issue: It's possible that there's an issue with the transmission that's preventing the bike from going into gear and the kickstart from moving. This could be caused by a variety of issues, such as a broken shift fork or worn gears. You may need to have the transmission inspected and repaired.
- Top-end issue: If the bike lost a lot of power before cutting out, it's possible that there's an issue with the top end of the engine. This could be caused by worn piston rings, a damaged piston, or other issues. You may need to replace the top end of the engine to resolve this issue.
It's difficult to say for sure what the issue is without a more thorough inspection of the bike. I would recommend taking it to a mechanic who can diagnose the issue and provide a repair estimate.
2/26/2023 3:39:43 AM •
Yamaha...
•
Answered
on Feb 26, 2023
Yamaha 6hp 4 stroke fuel filter not filling with fuel.
It should be possible to test the pump for proper function - there should be no need to replace it hoping for a cure.
A fuel pump should suck at one end and blow at the other and this can be measured using appropriate gauges and if those measurements are satisfactory the amount of fuel pumped can be measured...
Such tests are fairly routine on wheeled vehicles and not only are they a valuable aid to correct diagnosis they remove all doubt when warranty work is involved.
2/18/2023 6:31:23 AM •
Yamaha...
•
Answered
on Feb 18, 2023
How to set the YAMAHA Fz400r MOTORCYLE timing mark
The Fz400r is a motorcycle engine produced by Yamaha. To set the timing mark on the Fz400r, follow these steps:
- Remove the side cover from the engine to expose the timing mark.
- Locate the timing mark on the rotor, which is a small line or notch on the outer edge of the rotor.
- Use a timing light to align the timing mark on the rotor with the "T" mark on the stator.
- Loosen the bolts that secure the stator plate in place.
- Adjust the position of the stator plate until the timing mark on the rotor is aligned with the "T" mark on the stator.
- Tighten the bolts that secure the stator plate in place.
- Reattach the side cover to the engine.
It's important to consult the Fz400r's service manual for detailed instructions on setting the timing mark and to ensure proper timing of the engine.
2/14/2023 11:15:54 PM •
Yamaha...
•
Answered
on Feb 14, 2023
My 2008 Yamaha V star mill turnover when I tried to start it but will not fire up. Why and I don't think I'm getting spark to my coil packs.
A motorcycle that turns over but doesn't start can be caused by a few different things. Some possible causes of the issue you are experiencing with your 2008 Yamaha V Star include:
- Fuel supply problem: If the fuel pump is not working properly or the fuel filter is clogged, it can prevent fuel from reaching the engine.
- Ignition system problem: If there is no spark at the coil packs, it could be due to a malfunctioning ignition module, a bad spark plug, or a problem with the ignition coil.
- Mechanical issue: If the engine is not getting compression, it could be due to a valve problem, a broken timing chain, or a seized piston.
- Electrical issue: If the engine is not getting power, it could be due to a dead battery, a corroded connection, or a problem with the starter.
It's best to check the battery and all the electrical connections first, also check if the spark plugs are fouled or damaged, if so change them
1/27/2023 4:56:48 PM •
Yamaha...
•
Answered
on Jan 27, 2023
2007 Yamaha v star 650 fuel milage?
frankly if it were mine and if runs great now then let it run .. the leaner the mixture the hotter the combustion which can burn valves. it might get better mileage after break-in but if 40 is what you got then 40 might be all you get.. Thats about what my vulcan gets. if you want really high MPG then you have to sacrifice speed .. a moped will get around 70MPG but it's not much fun and has no power to get out of the path of danger
12/24/2022 11:34:41 AM •
Yamaha...
•
Answered
on Dec 24, 2022
Wiring of yamaha 350 warrior stator 2003
https://quads.ddns.net/service-manuals/yamaha/Warrior.pdf ---------------------- https://www.manualslib.com/manual/941548/Yamaha-Yfm350x-Warrior.html
11/28/2022 4:54:13 PM •
Yamaha...
•
Answered
on Nov 28, 2022
Not finding what you are looking for?