20 Most Recent
2002 Suzuki GSX 750 F (Katana) Questions & Answers
2002 suzuki gsxr 750 had
Open your rear seat and you'll see a black cap covering a connector/harness on the left side of the seat. If you take the cap off, you'll see it appears to be a normal harness. With your key in the ignition and bike turned to "ON" (but not running), take a paperclip and short the two connectors out (by touching the two contacts together). This is known as a "ghetto dealer mode switch". It should display the error code on your display instead of just FI now. Here are what the codes mean:
Code List:
C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIPOVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C46 - EXHAUST CONTROL VALVE ACTUATOR (1000 ONLY)
I am not getting power to the coils
on the right side of the bike remove the bolts round housing inside is your ignition plate change the plate it is responsible for sending a impulse signal to the coils to fire, make sure the voltage signal is being sent if not change if it is sending the signal the coils at bad.
Suzuki gsx750f not sparking
Good possibility, You can check the out put voltage of the pickup coil. This has to be done with a "peak reading volt meter". There are some commercially available adaptors to insert in a standard volt meter for this check. With adapter installed, meter set to DC volts the reading across the leads from the pick up coil should be 3-7 volts at cranking speed. You should also confirm that you have battery voltage with the key & engine stop switch on at the cdi box as well as a good ground. I believe on a Suzuki this will be the orange/ white for battery voltage and the black will need to have contininity to ground. Also the orange/white at each coil should have battery voltage with key and engine stop switch on.
Misfire sound
compresion tsest could be a slightly bent valve, or valve too tight, inlet side.
Not finding what you are looking for?