I NEED TO BLEED THE
Easy job, thing to remember is not to let the fluid level to become to low, as air will enter the system, then things become more difficult, use a length of tube correct diamiter to fit tightly over the bleed nipple on the clutch slave cylinder, left hand side engine, protect the paintwork by placing a cloth around the nipple, place tube in container containing a small amount of fluid, this will omit air entering the system while the nipple is open, now undo the cap on the master cylinder, set the lever at number1 to give full movment of the cylinder, at this time it makes sense to replace all the fluid in this system, rember do not allow the fluid to run out completly,open the nipple, gently pull in the lever the fluid will be pumped out with this action, hold the lever in and dont let go until you have closed off the nipple, repeat this action untill all the fluid has been changed, thus omiting any air from the system your. System has now been bled.Pull lever in nipple open, close nipple release lever, repeat over and over, untill finished tighten nipple clean away any spilled fluid rite away, hope this helps. Paul