20 Most Recent
2003 kawasaki ZX-7R Questions & Answers
My idle cable came lose how do i fix it
You will find the Idle cable screw hole in the middle of the carbs between two and three, It screws directly in between the two at the bottom, You can quite clearly see the screw hole, You have to first take off the petrol tank, then the Air filter housing, It is best to take off the carbs as well for easier access to the Idle worm drive screw hole though, There are only four screws holding the carbs on via four thin duabley type clips, You will need a long X-head or a Phillips for this, You will need an 7 or 8mm socket and a 10mm socket for the tank and an 8mm socket for the Air filter housing, I hope this helps, :)
Im having problem with my
Hi. I believe the selonoid on the starter maybe the problem. If you can bench test the motor to check if it runs. Replace the selonoid and see. Good luck.
03 kawasaki zx7r. I am having a problem, when I
Hmmm... sounds like ur clutch is slipping!
U have to go down to ur nearest bike garage, and confirm my assessment. The engine rev is okay, but when u release the clutch and have it into a GEAR it doesn't move as wut u have driven before, CLUTCH is at FAULT!
Ur mechanic can replace those clutch for ur bike!
hope that helps u out!
Changing swingarms
The part numbers are different. You can make anything fit with enough work, but it's not just a drop-in part.
I put led turn singles
LED signals often need an extra resister in the circuit to give the flasher can enough load to flash
some have this already in the wiring provided, some need an accessory one
My 2003 ZX& jumps when
The clutch plates are dragging. This causes the clutch shaft to turn even when the bike is in neutral and the clutch is dis-engaged ( handle pulled in ). When the shift fork moves to engage 1st gear, the bike jumps due to the shaft rotation. When was the last oil change? Dirty oil can cause clutch drag. Also, are you using synthetic lubricants? Some of them can swell the cork on the friction plates and that swelling causes dragging.
Batter fully charged, clicking noise
If the brushes have worn out then all you will get is as you describe. You will get similar results if there is a bad connection on the starter motor as well. Check the power with a bulb connected with flex.
Changing the brushes is easy. Don't pay a fortune for a new starter!
Hope that helps.
I shorted the mane fuse
off the ignition switch then change the fuse and then switch on, if it doesnt work check your starting circuit cut-off relay
I have a kawasaki zx7
http://www.youtube.com/watch?v=b0evfObrIh8 Here you go. If you have any questions or comments press add comment in upper right corner, or email me at
[email protected]. :)
Derek Carden
Premium FixYa Team
Not finding what you are looking for?