20 Most Recent 2005 Qianjiang QJ125T-12C Questions & Answers

A dim headlight is caused by a bad ground connection. Locate the bad connection and clean it up then tighten it back down.

Hi,
What is the problem of your engine?

To change your oil filter remove oil drain plug drain oil into an oil pan clean and replace oil drain plug, then remove oil filter, pour a drop of clean oil onto a new oil filter, and lube gasket, then replace the old oil filter with the new oil filter. Finally, add clean oil to the motorcycle until the oil level window shows oil in the middle of the viewing window when the bike is upright. ,,,

you will have to trace the wires back and with the aid os a multimeter find where the fault is.

Under well-lit conditions look for any signs of punctures (such as nails or shards of glass) which might potentially lead to a loss of pressure or a blowout. Bulging or cracking might also occur on old tires; make sure you roll your bike forward in order to see all surface areas that come in contact with the road.,

As per reference, your question pls have the video https://www.youtube.com/watch?v=ZPkw4l7ZbO4

You may just need to locate the idle adjustment and turn it down a bit.

Check the drive belt for wear. If sides are worn you will not reach top speed.

I can't find a diagram. The small potentiometer on the control board likely serves as an adjustable component to fine-tune specific parameters. Here are some possibilities: Voltage Regulation: The potentiometer might control the output voltage. By adjusting it, you can set the desired charging voltage for different battery types (e.g., 6V or 12V). Current Limit Adjustment: It could be used to set the maximum charging current. Adjusting the potentiometer allows you to limit the charging current based on the battery's capacity and condition. Sensitivity or Threshold: Some potentiometers act as sensitivity controls. For example, it might adjust the threshold at which the charger switches between charging and maintenance modes. Setting the Potentiometer: Without the specific circuit diagram or detailed information about your charger, I recommend the following general steps: Observe the Potentiometer: Identify the potentiometer on the control board. Note its position and any markings (if present). Consult the User Manual: Check the user manual or operating instructions. It might provide guidance on adjusting the potentiometer. Trial and Error: If no specific instructions are available, start with the potentiometer set to its mid-position. Gradually adjust it while monitoring the charger's behavior (e.g., charging current, voltage). Observe how the charger responds to changes in the potentiometer setting. Fine-tune it based on your specific battery type and desired charging characteristics. Remember that precise adjustments depend on the charger's design and the battery you're charging.

The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.

Check fuel delivery ,or fuel filter