2005 Qianjiang QJ125-J - Answered Questions & Fixed issues
Can you?
No,But you canrecord from CD to tape,It doesn't have a cd burner,just a cd player.
Please rate this a fixya
Genral oil change
1.Get your supplies ready and expose your engine
2.Unscrew the Oil Filler Cap
3.Remove the Oil Drain Plug
4.Remove and Replace the Crush Washer
5.Clean the Oil Drain Plug
6.Remove the Oil Filter
7.Remove and Clean Plastic Mesh Filter
8.Lubricate the O-ring of the New Filter and Attach it to the Engine
9.Motorcycle Oil Change - Replace Oil Drain Plug & Plastic Mesh Filter Pour Oil
10.Check the Oil Level,,
Mud stain
depends on what material is stained..
Aluminium stains can be very tricky to get clean if not impossible...some cleaners will also cause a orange/reddish stain wich will not come out unless you use some harsh chemicals to get them out. problem is it's hard to get to those chemicals.
IF you happen to have a truck wash nearby where they wash the big trucks (18 wheelers)take your parts there and tell them to use some brightener on it it's a chemical that really cleans aluminium.it may cost you a little bit of money but that stuff really works and i haven't been able to find that stuff for private sale anywhere.
the number 2 reasons for stains on the bike are :
1) waiting to long to wash the bike some types of sand/mud especially the red dirt we have down south here will stain a bike if you leave it on the bike not only that it dries as hard as concrete and is very difficult to remove , so was your bike ASAP.
2) washing chemicals. Some chemicals / soaps when they are left too long on aluminium will leave stains as it reacts with the aluminium , these stains are almost impossible to get out. ,,,
Tires
Under well-lit conditions look for any signs of punctures (such as nails or shards of glass) which might potentially lead to a loss of pressure or a blowout. Bulging or cracking might also occur on old tires; make sure you roll your bike forward in order to see all surface areas that come in contact with the road.,
Motor running fast
You may just need to locate the idle adjustment and turn it down a bit.
10/22/2013 9:02:42 AM •
Qianjiang...
•
Answered
on Oct 22, 2013
•
56 views
What is the length of lift cables on a 1993 model 2693 hilo camper and any info on what after market part to use ? thanks
The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.
4/12/2024 1:26:15 AM •
Motorcycles
•
Answered
on Apr 12, 2024
•
17 views
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/28/2024 4:42:51 PM •
Motorcycles
•
Answered
on Feb 28, 2024
•
26 views
Not finding what you are looking for?