2006 Derbi GPR 125 Racing - Answered Questions & Fixed issues
Hi my derbi gpr 125
derbi gpr125 E2racing 54reg
indicators went off/lights/ sorted loose wire
possibly when i jetwahed it? has'nt started since, except when i got lights/indicators mended started, bike and it just revved up so high had to turn engine off or else blown up charged battery"YUSA"
and cleaned fouled spark plug any help would be much appriciated y.p.v.s went off now sorted whirling sound back working.
THANKS JUSTIN.
Engine
Your engine is gone. Sound or not it's dead.,
Will not start
If the bike only run when choke is on you may have have a plug metering jet. Small jet located in the carb body near the main jet.Jet could have unscrewed from carb due to vibration.
Hello
I have a Derbi
If the engine is turning over, then the battery is probably ok. I would suggest put the choke on and crank it over. If it does not start, then hold the throttle wide open. If it gets flooded, then this will allow enough air to level out the fuel. When an engine is flooded, it is best to hold the throttle all the way. The bike should start. If not you might spray a small amount of starting fluid in the air filter then start the engine. Don't use too much starting fluid. Just a small shot.
My Derbi City Cross will not start
I know you said you cleaned the carb, but maybe something got in the carb when trying to start the bike. Because it sure sounds like you have a clogged pilot jet.
10/21/2022 3:56:02 PM •
Derbi...
•
Answered
on Oct 21, 2022
•
52 views
How do I get rid of an airlock in the coolant system of a Derbi GPR 125 2009
Use a airlift or comparable coolant system air removal/refill system.You attach the unit to the coolant system filler and it vacuums all air from the system,then you use the supplied hose to return the coolant into the vacuumed system.This fills the system with just coolant and no air.
2/19/2019 10:58:33 PM •
Derbi...
•
Answered
on Feb 19, 2019
•
154 views
What is bore and stroke of my 50cc derbi
Visit two-stroke engine a four stroke one cylinder to cylinder four cylinders if you need to measure the borer and the bike is a part just use calipers or just look it up online
2/15/2015 12:39:28 AM •
Derbi...
•
Answered
on Feb 15, 2015
•
150 views
Not finding what you are looking for?