2007 Harley Davidson FLHT Electra Glide Standard - Answered Questions & Fixed issues

Duplicate question already answered

Harley Davidson Wiring Diagrams and Schematics

try checking the vent in the cap from your description it is starving for fuel under load

Once you have verified proper fluid level in the master cylinder, simply brake line with a new one, and rebuild or replace the caliper. Although the problem likely stemmed from an internally-deteriorated brake line, it may have caused damage to the caliper piston, so safety considerations dictate that you rebuild or replace the caliper as well. Also, just a procedural note, NEVER CRIMP THE BRAKE LINE WHEN SERVICING THE CALIPER. Simply plug the line end. (It is likely that the brake line was crimped during service at some point, ultimately leading to this failure.)

fuse needs replacing

Have you checked fuses yet and if so what ones are good or bad

For what??? Also what model and year??

What year and what question???

Remove the brake light wires from the switch, use one wrench to hold the fitting with and use another to loosen and renove the switch, replace the switch, install the two brake light wires, bleed the brakes and if you have ABS have a Harley dealer program the system after s brkae bleed etc.

At the end of the crankshaft in the primary

No, Check the bulbs first and then wiring and the switch.

I am sorry that my knowledge base does not go back to 94 but I hope you find out and will post a comment with the answer when you do.

This does not sound like any Harley I am familiar with so sorry I cannot help

Charging system is not providing necessary current and battery is getting draqined. Need to diagnose charging system and do a complete battery check at the same time.

Brake lights and running lights are two different circuits. Check the elements on the bulb to see if one element is burned out. If not check for an open in the running light wiring. Be sure the bulb is a two element bulb and that it is not installed in wrong sequence/position if it is a two contact socket which requiresa two contact bulb.

Go to HD dealership with bike serial number and order a new key

A tune up will vary from carburetted to EFI, what do you have, what year is yoiur bike.

But a new speedo

bad bulb