Need to know how to
Hi, not familiar with this model, but most rotor assemblys fit onto a taperd end of the crankshaft, locked in place with a woodruff key, vissible on removal, do not loose this when the rotor has been removed it may fall out of the crankshaft easily without notice, anyway remove the fixing bolt and observe the orofis for a thread, this may be in the depths of the rotor where the bolt was removed, or the outermost area where the nut head of the bolt affixes, threads in the outermost area are normaly left hand thread, anti clockwise, in the depths of the rotor the puller would be a normal clockwise thread, a large bolt screwed into here until it makes contact with the crankshaft, tightened as tight as possAnd then given a sharp blow with a hammer is somtimes all it takes to remove iit, my addvice would be not to use any object at the rear of it to pull or prise it off that may cause dammage