20 Most Recent 2007 Honda SCV 100 Lead Questions & Answers

Take wheel nuts off 5...undo Exhaust bolts 2.....let air out of tyre and slide off while pulling exhaust over

https://www.fixya.com/motorcycles/t29807725-find_starter_motor_2007_honda_scv_lead

https://www.bike-parts-honda.com/honda-motorcycle/100-SCOOTER/LEAD/2007/SCV100F5/Engine/STARTER-MOTOR/13KRP3E1/E__1000/1/37477

Hi, Flaxman_spoo and the usual suspects are: 1. Dirty or clogged air filter. 2. Faulty spark plug. 3. Bad Gas. 4. Improper oil level. 5. Improper chain adjustment and lubrication. 6. Low tire pressure. 7. Dirty or contaminated carburetor needs cleaning and tuning. 8. Broken carburetor spring. 9. Carburetor spring on backwards. 10. Vacuum leak on carburetor or intake boot. 11. Too much slack in the throttle cable 12. Clogged or faulty fuel pump filter or injectors. 13. Faulty pressure regulator. 14. Improper valve adjustment. 15. Slipping clutch. 16. Improper timing. 17. Low compression. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day. https://www.justanswer.com/motorcycle/7a0nz-honda-lead-100cc-scooter-will-rev-so-far.html https://www.bikechatforums.com/viewtopic.php?t=270992 https://www.tradebit.com/filedetail.php/279352047-download-scv100-lead-scv-100-03-service $15 https://www.partsfish.com/page/oem-parts-for-honda https://www.manualslib.com/manual/677488/Honda-Lead-Scv100.html

Learn how to fix the Honda CRF 100 by using the service manual. You can find it here at - Honda CRF 100 Service Manual

Look on the engine next to the oil filler cap. Honda mark the oil volume needed on the case.

Hi,
Open the maintenance door, under the seat at beside the flooring where your feett rested, you could see the engine and high tension wire( spark plug wire ). Pull and wiggle the spark plug wire and you could see the thing you seek.
Hope that helps you.
Thanks for using FixYa!

cable broken? Make sure when you run a new one to follow the path correctly, bad path and it will just break from friction (I know, it looks better but trust me, I've broken 2 before i realized the path was wrong)

The Power Steering has failed. There has been a factory recall for a suddenly failing electrical steering shaft, that could cause the rider to loose control. This does not have to be your problem but anyhow either the electronics or the pump failed. Error codes or messages usually have to be erased by a simple reset procedure or disconnecting a plug, after repairs are done.

Question edited for clarity, but no idea what you mean by - "What do I need to do to get the gay? The clutching gauge in again?" You issue is probably that all the clutch plates are glued together. Leaving a bike for 21 years will do that. https://www.google.com/search?q=1985+Honda+Gold+Wing+1200+stuck+clutch ..

Check the wiring, especially the engine earth lead.

On the bottom of your speedometer on the left side there is 2 buttons press the far left one for a couple of seconds and the light should go on