kawasaki Motorcycles - Page 4 - Recent Questions, Troubleshooting & Support
Keihin CVK-D36 carbs on a 20 yr old ZZR 600
It sounds like your bike has been sitting in storage for an extended period of time (a year or more) - and the carburetors are plugged up. If this is the case, they will need to be completely disassembled and cleaned out.
If it hasn't been sitting (and the carbs aren't plugged up) then check that all of the normal tune-up items have been performed, especially valve adjustment, oil and filters, spark plugs, etc. If this fails to produce positive results, perform a compression check on the engine. Each cylinder must be able to produce at least 140 psi of compression in order to run and idle properly.
Kawasaki 2001 zr7s. can i replace just the friction rings or should i replace all the rings?
In general It's always a good idea to do a complete clutch assembly all at once, especially if there is more than one clutch plate/ring. Before you start stripping the clutch down check the simple silly stuff first. Check all the linkages from the lever to the actual clutch. The issue could just be the cable or a linkage sticking. Check the cable sleeve is routed correctly as a tight turn in it can also cause it to bind.
If you can release the cable or get some slack on the cable, operate the clutch lever at the gearbox end with your hand. If it's stuck it's a clutch issue if it moves it's a cable or linkage issue.
How many miles are on the bike? Higher mileage? Do the whole clutch. If it's a Very Low mileage you will probably get away with just the friction plates.
*Note* If the bike has been ridden HARD this can also wear a clutch out faster.
If you've got the clutch stripped down take a Very good look at ALL the rings and plates on both sides and if there is any wear or damage change the whole thing.
5/5/2022 8:47:31 PM •
kawasaki...
•
Answered
on May 05, 2022
1995 220 Bayou. How can I replace choke cable?
https://www.quadcrazy.com/atvforum/topic/10672-1988-2002-kawasaki-bayou-220-service-manual/ https://www.cyclepedia.com/online-manuals/kawasaki-atv-motorcycle-online-manuals/kawasaki-klf250-bayou-atv-online-service-manual/
5/5/2022 4:33:26 PM •
kawasaki...
•
Answered
on May 05, 2022
I have a 2001 kawasaki zr7s. My clutch is acting
the "cluch push rod" should be pushed back by the cluch springs, if there was a bearing on the end it would have broken up and be laying inside the cluch case in bits! if you have taken the cluch to bits there is a thrust washer behind the cluch body and gear box shaft if you left this washer out you wont have a cluch? best bet is get a hayns service book for your bike maybe off e-bay and you will have all the info you need to fix it plus all the photos as well of all the parts
F1 mean with flashing red light
Is it only when the bike is running is it on all the time? Does it have a diagram? It could either be temp, oil or service.
F1 mean and flashing red light
The light will be FI for fuel injection, it is the equivalent of a check engine light on a car. Take the bike in for a service so the tech can download the fault codes.
Not finding what you are looking for?