Volvo Cars & Trucks - Page 6 - Recent Questions, Troubleshooting & Support

Hi, Codes like these can usually be found within the troubleshooting section of your car manual. Please start by looking for the procedure to overcome the error there. Please take note of whether the error comes on after you've accidentally performed a certain action in your vehicle (ie removing seat belt, winding down windows etc). Thank you.

Question edited for clarity, add make name. Question moved to model category. Yes you can, you remove the AC compressor and put a bypass pulley in its place. The routing and belt stays the same. https://www.google.com/search?q=2004+volvo+s60+ac+bypass+pulley ..

P242F is excessive ash accumulation in the Diesel Particulate Filter (DPF). Cure is replacement of DPF at £400!

Hi, Please check your alternator to see if it's functioning properly. If so, you can attempt to jumpstart your vehicle again. Also, please only change bulbs while the car is turned off. If current was running through your vehicle and didn't find the expected resistor (within your bulb), this might have cause somewhat of a short circuit - even though I think that manufacturer would have built protection for this. Thank you.

weak engine? check fuses scan the PCM? Volvo L25B compact wheel loader filters dirty weak pump bad diesel fuel. google why any diesel is weaK

NO YEAR TOLD OR cOUNTRY OR ENGINE TOLD. (HARD CASE) 1985 to 2013? not car, but is a huge heavy truck, we don;t have huge truck forum here. 12 to 21 TON rated. 9 ton load. 10 liter engine diesel . TD102 FL" stands for "Forward Control" and "Low-level Cab".[1] The FL6 and the larger FL7 and FL10 appeared in the summer of 1985. sold until , year, ? IDK my wild wild guess is a bad FUEL Pump. or filters bad, or bad fuel, or lost pump prime. (air in lines or sucked in) injector failing. intermittently. cuts out has huge list of causes. (fuel or lost DC power) sure electric sure lots of other causes only tests done prove the pudd'n cuts out means what>? engine stall ? stalls fast, or slow. engine misfires first (shake?) or just bogs slow and stalls nice and easy stall.? do any other electrics fail same time ,like head lamps, IP cluster goes dead, heater blower dies., radio dies. or?

There's an access plug above the license plate. Remove the cover on it and the keyhole will reveal itself to you.

The Used 2003 Volvo C70 Convertible comes with front wheel drive. Available transmissions include: 5-speed automatic, 5-speed manual.

Volvo has had a lot of trouble with relays in the rear control module. Check/replace the relays for the rear lights with the updated relays.

Could be a bad (VSS) Vehicle Speed Sensor. Check it its located on your transmission. Good luck

Front side markers are located in the headlight assembly.

Black smoke is rich mixture, so something is wrong with the fuel management system. Get is connected to a pro grade scan tool computer and check long term and short term fuel trim. Check for fault codes on sensors. https://www.google.com/search?q=volvo+xc90+d5+black+smoke ..

no car owned ever saved me money for 50 years. why not diagnose it first and worry cost last. find the truth first some failures are each to fix. HVAC topic cars. well all you can do is 2 things.

• check fuses.
• get it scanned. many shops/stores do it for free.

blower (fan) WORKS BUT CONTROLS DEAD. TO HVAC ask dad for help? or brother, or uncle?????? not told at all blower spins but does it push(blow) air to any vents (MODES)? blower works but fails on heater and cold to all vents or just some. if the heater work and cold air fails on all vents that can be A/C failure under the hood or the controls are stuck in heater mode. there are many tests to find out if problem is in the dash or under the hood; , lots of tests. the cause can be just a loose wire, or vastly more complex a evap core blown. (just did mine last week)$$$$$$$

MA2304 - 5 injectors 4 solenoid valve, low voltage Best I can do.

XC-70 (typo) YES. ALL CARS MADE, FOR SURE LAST 20 YEAR. HAVE FULL SERVICE MANUAL THAT COVER ALL THAT AND 1ZILLION MORE TOPICS. ALL DO older cars too, but are weaker before manuals were in digital form. for sure 2007! you posted with not country, and what engines is actually there. ours USA is. 2.5L L5 engine and 2.4L has x6---- O-RINGS here. in, inch/lbs, Divide by 12 to get foot/lbs a diagram what? a VC? not sure what that means , and all that is in the SM service manual. CAN I ASSUME, you need all 10 steps in the manual told to you?>

1. Before servicing the vehicle, refer to the Precautions Section.
2. Remove intake manifold. Refer to Intake Manifold removal and installation.
3. Remove spark plugs from:
   • Cylinders 1 and 5-5-cylinder engine
   • Cylinders 2 and 5-6-cylinder engine
4. Install two camshaft cover press tools 999 5454 into the vacated spark plug holes. Ensure that the bolt in the spark plug well is fully tightened 22 ft. lbs. (30 Nm).
5. Remove Variable Valve Timing (VVT) solenoid.
6. Leave a 0.079-0.118 inch (2-3mm) gap to the camshaft cover when installing the press tools 999 5454
7. Remove all bolts securing the camshaft cover to cylinder head.
8. Use pliers 999 5670 to lift camshaft cover from cylinder head.
   • Install pliers at the stop lugs. Start with cylinder 1 and work alternately backwards.
   • Slacken off the wing nuts approximately 2 turns.
9. • Repeat the procedure working toward rear of engine.
   • Carefully press out the front and rear camshaft seals.
   • Remove the two press tools 999 5454 from spark plug holes.
   • Remove the camshaft cover.

that? the install is more complex , including sealants. and tighten the bolts in sequence from the center and outwards to 88 inch lbs. (10 Nm). and

1. Install:
   • Variable valve timing (VVT) solenoid. Use a new gasket. Tighten center bolt to 89 ft. lbs. (120 Nm), center plug to 26 ft. lbs. (35 Nm)
   • Spark plugs and tighten to 22 ft. lbs. (30 Nm)
   • Intake Manifold, refer to Intake Manifold removal and installation

and more, read the manual. RTM https://eautorepair.net/Marketing/Default.asp .

Check the bonnet light switch. It is probably stuck or may need adjusting.

think itsa a chain on this engine but cannot remember as i work on so many different cars ,if its a chain then leave it alone unless its noisey .

https://mechanicbase.com/airbag/reset-airbag-light-without-scanner/ This might help.

engine lights also report on transmission problems and if you are getting a transmission service light on then you should be talking to an accredited professional transmission service center that has experience on your vehicle and get it serviced

check the bulb. if its not the bulb check your fuse.