Toyota Camry Solara - Recent Questions, Troubleshooting & Support - Page 6
Shift solonoid e e is for external it the one on top of trans two screws and a plug on top it not on top Marc is correct I think I looked up camry and not solara thank you
First, check your information on the location of the shift solenoid in the Camry Solara. It is like most cars on the road. The shift solenoid is located under the drain pan cover on the valve body wall (the valve body faces the drain pan cover. To access it, you will have to do this:
- Wait until the transmission is cool and the fluid has settled
- Drain the transmission fluid (depending on brand automatics have up to 9.5 quarters of automatic transmission fluid in them so you can see the necessity of draining it first. Instead of having a rush of tranny fluid gushing out at you, you are only facing about one quart)
- Place a bucket under the transmission drain pan cover
- Loosen the 14 bolts along the cover flange
- Gently place the transmission pan cover into the bucket
- Let the quart or so that is left in the transmission drain out
- Look at the valve body, just revealed by the removal of the fluid and cover
- Locate the solenoid on the upper right of the valve body
- Replace the right-hand one first
When I turn on my headlights the dash board goes black. The dimmer switch is not the issue
The dash lights are connected to the park lights. Check to see if the park lights come on. If no park lights, suspect a fuse or wiring issue. If park lights are ok, try slapping your hand on the dash area above the instrument panel to see if the lights come on/flicker. If there is a change, the instrument cluster assembly/electronics are the most likely cause of this problem
How to replace a rear wheel stud
remove the wheel
using a hammer and punch knock the broken stud out
fit the new stud from behind use over size nuts as spacers fit the stud nut and apply tension
using the hammer and punch from the rear on the head of the stud knock it in as you keep the tension on the stud nut
keep the process going until the stud is fully seated on the head of the stud
Over heating only at highway speeds
Is your rad fluid up where it should be?
Is your rad plugged so air can't flow or does it need to be flushed?
Replace your thermostat That may be the problem as well. If your fluid is up I would change the thermostat.as that is a likely problem.
Check all hoses and make sure they are not kinked as well..
How to install serpinte belt 2005 v6
If you are serious about this you need a repair manual. Your library may have one. While the belt is a reasonably priced item,
The skill and knowledge is above average.
Not finding what you are looking for?