Toyota Camry Solara - Recent Questions, Troubleshooting & Support - Page 3

i would check your throttle posintion sensor sound like its been going for some time now . some call it your T>P>S> hope that works for you

Check mounting surfaces at antenna. Corrosion or looseness and the antenna loses its ground to the body.

The sending unit in the tank. If you need further help, reach me via phone at https://www.6ya.com/expert/jason_e95d2f9c1ac9610d

If the seat track mechanism has play, it is possible that it is binding up because it reached the rearward limit of its travel, stalling the motor. You can try having someone <carefully> force the seat forward from behind as you engage the "forward" function of the switch. This may be enough to "unbind" the mechanism- if this is the issue. Otherwise, it is likely that the forward function of the ower seat switch is no longer working. You could try to spray some electrical contact cleaner into the switch (being careful not to stain the seat upholstery), let it dry and then try the switch again, possibly wiggling it as you push it forward. If this works, it is likely a temporary fix and you should replace the switch to prevent it happening again.

What's the code #?

yes

Sit in back seat passenger side. Remove panel which is on top which is below rear window, same panel where seat belt goes into panel at top. You will need to remove #2 Phillips screws which hold panel in place. Screws are hiding behind seat belt front cover where belt goes down in panel, under cup holder which allows arm rest cover to lift off and one more right on left side of head rest in corner. Remove panel. You will see switch which is in vertical position. If for any reason you want to by-pass switch, just unplug switch. Radio will still work in standard mode. The amp sound will not increase in performance when top is down and sound will not be as sharp.

go have the code read most auto shops offer service for free the code is starting point for repair

didnt specify vehicle --generic answer --if key doesnt work on door then you have two problems --if fob doesnt open drivers door and other doors try changing fob battery -if no go either need locksmith or AAA service to slim door ---also if key doesnt open door possible lock linkage damage or disconnect --rare that both would happen and lastly make sure using proper fob and key

First,as you travel over a rough road that causes the rattle apply the brakes slightly,is the rattle gone now?If so it's loosely mounted brake pads and/or worn brake caliper mounting bolts/sliders. Rattle still there with your foot on the brake?Then it's usually the sway bar links and/or sway bar bushings. To check this sway bar noise,disconnect the sway bar links and tie the bar up/out of the way and try that same road. No noise now? address sway bar bushings and/or links. Still noise?Might be struts. If someone tells you,.you have loose lower control arm bushings,have them show you the play in the bushings before you spend any $$$.

you gave up on the wrangler. fuses wires battery dead. use a voltmeter to find power loss this is just basic electrics 101. why is this hard? grab meter grap schematic off mitchells read it now probe the noid to find the point of 12vdc loss. same on all cars.