1990 Mazda RX-7 Logo

Related Topics:

Posted on Aug 04, 2011

Have a 86 rx7 turn signals click but no flash im assumein like on most other cars its the little 5 dollar flasher bout the size of a quarter in diameter an bout an inch or two long .... just eed to know where its located at? an it is a gxl hatchback if that makes any diffrence at all

2 Related Answers

Anonymous

  • 228 Answers
  • Posted on Dec 07, 2010

SOURCE: My rx7 Gxl is making a loud clanking noise when I

throw-out bearing or diaphram going bad. is it hard to put in gear?

Ad
czaa

Arnie Burke

  • 7339 Answers
  • Posted on Nov 25, 2011

SOURCE: 1988 mazda rx7 gxl

whats the problem

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is on 1987 pontiac 6000 are the bulbs for turn signals How do I get to them? & or the flasher ? Is it in the fuse box?

The turn signals at the rear share the same bulb, same filament on the bulb even, as the brake lights. So if you have brake lights, the rear turn signal bulbs are good. If I recall, you access the rear bulbs from inside the trunk, and pretty easy to change bulbs. Look for a panel or trim piece in the trunk that covers the light bulb assemblies. You turn the bulb sockets a quarter turn counter-clockwise and pull them out, then you can replace the bulbs. They are two filament bulbs-one filament for the park lights (tail lights) and one filament that serves for brakes and turn signals together.
The flasher unit is a small round cylinder, I don't believe it was in the fuse box, but located up under the dash, close to the steering column. The hazard flasher unit was also up under there and looks the same. Look for them on a bracket near or by the steering column, possibly one on each side of the steering column To find the turn flasher, turn your hazard switch on. The little round unit that is clicking-you may hear it or feel it click with your finger on it-is the hazard flasher. The turn flasher will be the one that is not clicking. A little round cylinder is how you identify it.
1helpful
1answer

4 ways work but turning signals do not

flasher fuse needs replaced, usually have 2 one for flashers, and 1 for turn signals may be in fuse box, or just close to steering column usually a round metal type about a (quarter size round)
0helpful
1answer

My turn signals aren't working. The hazards work but when I put the lever up the turn signals don't go on. All I hear is buzzing but no clicking or flashing. Is there a fuse or something that I have to...

it sounds like you just have a bad flasher. its typically the size of a "c" battery and located under the dash on the driver side, no tools needed just twist it off and twist on a new one 5-15 dollars
0helpful
2answers

Where can I find a fuse box diagram for my 1985 grand marquis. my blinkers stopped flashing. they work but do not flash

Your fuse box should have a big round thing plugged into it called a flasher. Little bigger than a quarter. Simply unplug it and replace it
1helpful
2answers

The turn signals will not work on my 1985 mazda rx7

most likely the flasher unit is dead , it is a cheap , plug in part that is usually found in the fuse box. I am not familiar with rx7's but i am sure you can find a fuse box diagram on line somewhere.
7helpful
4answers

92 buick park avenue turn signals wil not flash

Oh you'll love this I just fixed that problem. Yes there is a flasher fuse there are actually three. One in the fuse box and two under the dash panel. Drop your plastic panel at the bottom and look for two half a dollar sized round fuses those are your flasher fuses. They run around two bucks at your nearest auto part I would replace both so you want have that problem again but yes there is a flasher fuse for it. Good luck
4helpful
2answers

Where is my falsher relay located? I have a 1998 Toyota Camry CE. HELP!

With your key on give a left or right turn signal. Try to listen and pinpoint the clicking of the turn signal flasher. Once you locate the turn signal flasher, your hazard flasher will look just like this and should be mounted nearby, typically next to it. The flasher simply pulls out and the new one just pushes in
0helpful
1answer

Turn signals don't work on my Olds 94 cutlass ciera

I think its under the hood in the main fuse panel, its a round 2 or 3 prong silver looking flasher switch about as big around as a half dollar, bout a inch thick.
0helpful
1answer

Turn signals

Check the thermal flasher. It is a little metal can about the size of a quarter located (usually) in the interior fuse panel. This panel usually located in the dash just to the left of where the drivers knee would be. You can get a replacement at any auto parts store.

Hope this helps Loringh PS Please leave a rating if appropriate Thanks
Not finding what you are looking for?

60 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...