Keyless remote won't work. how do I get in the trunk

Use your key to unlock the door / trunk. If your car starts up; it might just be a connector and / or your battery in your remote. Try the simple / cheaper fix check by checking the connectors leading to the trunk release solenoid.

I would replace the remote, this remote is very prone to this type of problem.

Does the spare remote work? Have you tried to reprogram it? These remotes are very cheaply made and prone to key pad failure. To program the remote click this LINK, if that doesn't work buy anew one on eBay for cheap.

When you press the trunk open button, do you hear any "release" noise come from the trunk area? The issue may be a bad battery in the key fob OR there could be an issue with the transmitter located inside the vehicle. Do the doors lock and unlock properly? is the vehicle equipped with security or immobilizer? please advise

i dont think that your 04 camry has a remote start unless it is an aftermarket installed keyless entry
and remote start. my 03 toyota remote has lock,unlock,trunk onfront of remote and panic button on
the back that is red.

Check to make sure the button on the trunk latch is turned from manual unlock...they made that feature so only the key will work to open the trunk that way if someone breaks in the front of your car they can't hit the trunk release and get into the trunk...may be the same thing for your remote. Hope that helps.

Might possibly be. Pontiacs were really tied into that anti theft security system. They were notorious for breaking. Here is a link to a site about these SECURITY systems. And possible DO IT YOURSELF solutions. http://vatspasslockpasskeysecurityhelp.yolasite.com/

Trunk reless relay ! Which year is right ? at the top is shows 1992 Buick . An it also has 2005 ? Which is it ?

try programming the remote again, here is how u do that. if this doesn't fix the problem the remote may be defective, if you need a new one try ebay, they are very cheap to buy there.

.

Note: Existing keyless remotes will be erased with this procedure.
Existing working remotes will have to reprogrammed also.
1. Locate the programming connector wire located in the RH trunk area.
You may have to pull back right side trunk trim on trunk wall to locate
the single black/white wire.

2. The programming connector wire should have one termial in the plastic
connector on end of black/white wire. Ground the terminal in the connector
to a nearby bolt or trunk latch.
Leave connector wire connected to ground through out procedure.
3. System will now lock and unlock doors automatically to indicate
programming mode has been activated.
4. Press any button on keyless remote. System will respond by locking
and unlocking doors one time to indicate successful programming.
5. Repeat step 4 for to program any additonal keyless remotes including
and existing keyless remotes. Do not remove ground wire between
programming of keyless remotes.
6. Disconnect programming connector wire from ground to exit programming
mode.
7. Test keyless remote(s).