Serpentine belt diagram
There is a tensioner pulley attached to an arm.
Release the tension on the belt by undoing the pulley arm bolt, the
belt will have enough slack to slide off the pulleys.
To put it back
on, you find the diagram on the radiator guard or under the hood.
The routing of the serpentine belt on your car is quite simple, if you do not have the diagram just note position of the belt on the pullings by making a drawing on a piece of paper.
Another choice is getting the repair manual for your car, if you wnt to DIY, sooner or later you are gonna need it.
×
Fig. Fig. 8: You can use a box-end wrench on the pulley nut to rotate the tensioner ... 
Fig. Fig. 9: ... then remove the belt from the pulleys 
Fig. Fig. 10: Serpentine drive belt routing and removal - 3.8L (VIN L) engine shown, VIN C similar 
Fig. Fig. 11: Make sure to note the drive belt routing prior to removing it - 3.8L (VIN K) engine shown 
Fig. Fig. 12: Drive belt removal on a 1992-95 supercharged engine 
Fig. Fig. 13: Many vehicles have a label you can check to be sure the belt is installed and routed correctly 
hope this is what youre looking for
499 views
Usually answered in minutes!
thank you
×