SOURCE: Interior Door Handle
It should be able to be replaced without removing the door panel.
However, removing the door panel is a very simple process. Remove the bolts through the armrest, and pop the door panel loose (it's held on with plastic friction clips) They do make a tool for removing the panel, (just a couple of bucks) or if you're carefule, you can do it with a putty knife and a screw driver ((basically you pry the panel away from the door, replacement is just popping it back on.
Once it's loose, slide up, it is hooked over into the window channel (you do want to have the window down).
SOURCE: handle on rear hatch door broke off.how can i open hatch door until i can get a new handle?
you don't. take it into a Hyndai Dealership and have the handle repaired/replaced. The rear hatch panel/cover has to be removed (from inside the vehicle) to access the hatch latch and open the door.. from that point the handle can be replaced/repaired.
SOURCE: how do i remove rear drivers side door panel in
Most door panels are just cliped in but you do have some screws. stars, if you start at upper right and to the right your first one is in the door pull or opener area, then there is one inside the light at the edge of panel. (if this is appacable). pull up and away from door slowly to make sure that all screws have been removed and that you do not pull apart any wires.
SOURCE: Hyundai accent 1997, the driver side door handle broke
taking off the door panel is a lot of work. i can explain it all to you if you still have the same problem. i've replaced all of my door handles for all 4 of my hyundai's doors, so i'm experienced in this department. would you like a step by step walkthrough still?
SOURCE: Removing door panel on 1997 Hyundai Accent
Look under the round part of the handle,see if there is a small allen screw there,if it is unscrew it until the handle comes off.if not send a new message
87 views
Usually answered in minutes!
×