The rear passenger side window won't work, we think that it fell off the track because it won't go up or down. We hear the noted working but we see a cable conected somewhere around the mirror we don't know if its the track or window, and the cable is also connected to the motor. We just don't know how to fix the window so it will roll up and down again

Really easy to test with a 12v test light. If the plug gets power when you push the switch I'd think it would be a bad motor.

It may have slid off the track from the water. If it doesn't start working once it dries out, a day or two depending on the weather, take the door panel off to make sure it is on the track properly and that the cables/wires have not corroded.

Window regulator is bad in the drivers door . Do you know what a regulator is ? The Trainer 24 Power Window Troubleshooting Do you know anything about automotive electrical testing ? How to read an use a wiring diagram ? Do you know there are two side to a electrical circuit ? B+ voltage an a ground side . Plus there is electronic control modules and class 2 serial data network involved . When you push the switch for a window othen then drivers window on the drivers door . a class 2 message is sent to the other doors modules . The correct module will then open it's window .
http://www.bbbind.com/free_tsb.html Check out free wiring diagram here .Enter vehicle info . year , make , model and engine size. Under system click on body & accessories , subsystem click power windows . Click search button , then click each link one at a time .

some of them run with a wire this my have corroded and snaped take of door panel and check this

replace the window regulator the cable prob. broke

You may have a number of problems, all can be answered by removing the door pnl and inspecting. The window may have fallen out of the track, the window motor may have fallen out of the regulator, the motor's drive system may have stripped or broken, the regulator itself may have failed or broken or the window is no longer attached to the regulator. Pull the pnl and start inspecting. Good luck!

You also have Circuit Breakers for your windows, Or your Master Switch ,You can Test the Driver Control Switch or the rear switches by removing the Switches and using the connector Plug and a Jump wire try jumping accross the wires,if they go up or down you could have a Bad Switch,if nothing moves more than likely your Window Motor is bad. BUT first CHECK your Circuit Breakers ,It could be Labeled as accessery Relay or circuit Breaker.

This sounds like a stuck switch,try to unplug the switch (drivers side window) first and it should cure your problem.Let me know if this does it,,if not i will help you solve this issue

The cable is broken. And unfortunately the motor track and cable is probably one whole assembly. So you need to replace it all as it is one unit.

its come off the track and hold down inside the door , remove the panel inspect the window glass at the bottom, some have holes in them that a vinyl insert clamps to, and others are secured with only a double sided tape,, one or the other of these has come loose