SOURCE: noisy rear bearing?
Is isnt the rear end it would be very bad shaking and wouldnt last long because it would throw a bearing out. So its most likly the wheel bearing and you can just take it to a local automotive shop.
SOURCE: how to change a rear wheel bearing on a 1994 toyota camry
The rear wheel bearing on a toyota camry is replaced by replacing the wheel bearing and hub as a unit. this is a design change as compare to older models with two piece wheel bearings. Scotch drive wheels. Remove rear wheel. Remove rear brake drum. (note: if emergency brakes are applied you will not be able to remove brake drum) Remove dust cap and hub retaining nut. Hub should slide off as unit. Replace hub with new unit. Installation is reverse of removal.
SOURCE: changing a wheel bearing
it would be replaced as a bearing housing assembly which is a bolt on unit .
SOURCE: replacing 1988 toyota 4 wheel drive truck rear end
You do not not a press for this job. Good old fashion elbow grease and a block and sledge work fine. Be careful not to mushroom head the spindle though, total pain in the *** job but pretty simple.
SOURCE: Noise coming right front wheel. I assume that it
whole assembly has to be changed, the bearing is one non-dissasemblable unit, it has to be pressed out and in. best done by someone who has the right tools.
118 views
Usually answered in minutes!
×