How to match the main bearings color code for the honda prelude

I wish it were that easy. First, you need the service manual. You need to write down the exact model of your engine (d15b7?). To get the main bearings, you need to write down the letter/number combination in the bell housing area. Then, you need all the numbers/ letters off the crankshaft. Take them down to the dealer and they can match them up to "colors." You have to order bearings by color from the dealer. That is the only way you will get the right stuff. If you want rod bearings too, then you need the number/letter off each rod also....

Rock Auto.Com --- on internet

$129.79 for standard
$206.79 for wells brand

You need to know that is the problem

You install yourself in about 5 min
Don't need a repair shop

Here's all of them for you to be sure. I hope this helps you and good luck.

1995 Honda Prelude Stereo Wiring Constant 12V+ Blue/White Switched 12V+ Yellow/Red Ground Black Illumination Red/Black Dimmer n/a Antenna Right Rear Front Speakers 6 1/2" Doors Left Front (+) Blue/Green Left Front (-) Gray/Black Right Front (+) Red/Green Right Front (-) Brown/Black Rear Speakers 6 1/2" Rear Deck Left Rear (+) Blue/Yellow Left Rear (-) Gray/White Right Rear (+) Red/Yellow Right Rear (-) Brown/White

the specs for the 1991 prelude with a 2.1 engine are, the connecting rod caps are 34 ftlbs and the main bearing cap are 49 ft lbs, hope this helps,

Check in your owner's manual packet. In my Audi, there was a supplemental guidebook for the audio system, and the security code was on a card in that packet. If it's not in there, you can go to the dealership with the car to get it - they can look it up based on the VIN of the vehicle.

You'll need the title to the vehicle (to prove it's your car), photo ID (to match you to the name on the title), and the car itself. The dealer will then put the code in for you (make sure they give you the code written down, and show you how to enter it for the next time you need it). The downside to this is that they'll probably charge you labor for doing this.

This may also be a warped flywheel.

80 pounds.

the main fuse is atached to the side of the fuse box under the coin box you need to pull the fuse box out

bad bearings in the hubs can cause it try changing your hubs (hubs are sealed units when the grease in them dry out you need new 1's)

http://www.tegger.com/hondafaq/startproblems.html#mainrelay see EFI Main Relay, half way down page