Spark plug wire placement on coil - Cutlass Ciera Oldsmobile Cars & Trucks

The 1985 Suzuki GS700ES is a motorcycle that is equipped with two coil packs, each responsible for providing the spark to two cylinders. To determine which wire from the coil pack goes to which spark plug, you can consult the wiring diagram for your motorcycle.
If you don't have a wiring diagram, you can also determine the correct wire placement by using a spark tester. To do this, you'll need to disconnect one of the spark plug wires from a spark plug and connect it to the spark tester. Then, turn on the engine and observe which spark plug is firing. Repeat this process for each of the remaining spark plug wires until you have determined the correct placement for all of the wires.
It's important to ensure that the wires are properly connected, as incorrect placement can result in poor engine performance or damage to the ignition system.

Heres the firing order and distributor plug wire placement u should also check for bad plug wires get your car in the dark and start it watch the plug wires if thier bad they will light up like a Christmas tree you will see them sparking on the block I'd check them first hope this helps

Google it. Links won't post but there is tons of info on that engine. Users 3 packs that sit beside each other. Firing order 1 6 5 4 3 2
coils are from front to back 1 4 5 2 3 6

have all the spark plugs been replaced when you have 1 bad spark plug you should replace them all same thing goes with the plug wire you can have the coil tested at the parts store i would replace the spark plugs and wires then go from there.

the firing order is 123456 pretty easy, but i think what you want is spark plug location on the coil packs, so lets start with cylinder placement. starting at the front of the engine the end with the belt the three cylinders closest to the radiator are 2 4 6 the cylinders at the back of the engine are 1 3 5 the spark plug wire location is from the front of the coil pack( fount of engine ) 1 4 6 3 2 5......HAVE FUN

do not have a diagram, but heres the firing order. 1-2-3-4-5-6, 1-3-5 is in back, # 1 is closest to alternator. from left to right, or facing engine from front 2-4-6 is in front. 5-2-3-6-4-1 is coil pack, from left to right (facing from front of engine).

According to Saturn timing specifications, the internal firing order for the Saturn 1.9L motor, both Single overhead cam, or Twin cam is as follows:
Left to right 1-3-4-2

If you are routing spark plug wires, and need to know the order of wires from the coils to the engine, the order is as follows:
Left to right 4-1-2-3

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

You dont need diagram. If you will notice there is seperate coils for each spark plug. you need 9/32 socket to remove each coil. Theres a small screw that holds the coil in place, Remove the srew, remove the coil, once you remove the coil take a spark plug socket and extension to remove the plug.On the end of each coil is a boot that looks like the end of a spark plug wire . You can buy a set of those boots.Do these one at a time. You can gat a book a auto parts store that could help for about twenty bucks. Hope this helps Leave comment

if you replace one by one you dont need a firing order.

AutoZone has your answer here.